User manual CLIFFORD SUPERNOVA II

[. . . ] World-Class Auto Security TM SuperNova II Owner's Manual Table of Contents Standard Features of the SuperNova II . 3 Welcome . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Your 3-button/3-channel remote controls . 8 Anti-CodeGrabbing (ACG) with Random Code Encryption . [. . . ] For instance, when having your car serviced, washed or parked by a valet. Your factory-set valet code is the single digit "2. " NOTE: If you temporarily lose the use of your remote controls, you can disarm the system by enabling valet mode. Definitions Digit: A digit is defined as any number from 1 to 9, inclusive. Valet code: A valet code may be 1 to 3 digits: A one-digit code=X=any number between 1-9 A two-digit code=XY=any number between 11-99 (excluding numbers with zeros) A three-digit code=XYZ=any number between 111-999 (excluding numbers with zeros) Remember, no code can have a zero. PlainView switch: A rocker switch mounted on the dashboard or console. The switch has three positions: 1. ) Latched 2. ) Center 3. ) Spring-loaded momentary. When you press the latched side, the switch remains in its pressed position. When you press the momentary side, the switch bounces back to the center position. Entering a digit: To enter a digit, you tap (press and release) on the momentary side of the PlainView switch the number of times corresponding to the numeral of the digit to be entered, followed by pressing to the latched side, then returning the switch to its center position. Entering a code: If your code has only one digit, enter the code as described in "Entering a digit. " If your code has more than one digit, just repeat the above for each digit of your code. 11 To enable valet mode 1. Turn the ignition switch to its "ON" position or start the engine. Enter your secret valet code on the PlainView switch (the LED will turn on), then return the switch to its center position. You now have 10 seconds to press the latched position to enter valet mode. The LED will glow continually for on-going visual confirmation of valet mode. To exit valet mode 1. Turn the ignition switch to its "ON" position or start the engine. Flick the switch back to its center position. The LED will turn off to confirm that the system is now in its normal operating mode. Setting your own secret valet code Since all Clifford systems have the same factory-set code, it is highly advisable that you set your own valet code. You may choose any 1-, 2-, or 3-digit code that does not have any zeros. You can also change your valet code whenever you want. Simply write down the 1-to-3 digit code you wish to use (remember, no zeros in the code), then perform the following steps. Enter your current valet code (the factory-set code is the single digit 2: two presses of the momentary side, then latched). Press and release the switch's momentary side 16 times. To help you count, you will hear a single chirp confirmation each time you press the momentary side, for a total of 16 chirps. Immediately after the 16th chirp, press the latched side of the switch, enter your new code. Wait 3 seconds until you hear 1 chirp and the LED turns off. Turn the ignition off after you hear the 1 chirp and the LED has turned off. VERY IMPORTANT: You must immediately test your new secret valet code: Turn on the ignition, enter your new code, then flip the switch to its latched position. [. . . ] The system comes from the factory with all of its features pre-programmed as noted in the table below and on the next page. To change any of the settings, use the following procedure. To restore the feature to its factory setting, just repeat the procedure: 1. Select the feature you wish to program from the table below and on the following page. [. . . ]