User manual CLIP SONIC SL216

[. . . ] Refer to the description and matrix for SEL_Pll2 pin 116. Refer to the description and matrix for SEL_PLL2 pin 116. audio transmit serial data ports 2 and 3. Definitions Servo data PLL interface reference current generator connect a resistor between this pin and ground to set reference current . [. . . ] ANGLE MARK -- GENERAL PAGE -TV DISPLY PIC M O DE ANGLE M ARK OSD LANG CAPTIONS SCR SAVER M AIN PAGE This feature is functioned only for the disc, which has ANGLE function: ON OFF When the ANGLE MARK is set ON, the screen displays the mark. When the ANGLE MARK is set OFF, the mark is not displayed. SCR SAVER -- GENERAL PAGE -TV DISPLAY PIC M ODE ANGLE M ARK OSD LANG CAPTIONS SCR SAVER M AIN PAGE When the unit is stopped, no operation, no function button is pressed in 1 minute, screen saver appears for the purpose to protect the TV screen if SCR SAVER is set ON. 1 channels can be preformed only if Downmix is set OFF and the rest of other setup can be activated. CNTR DELAY Adjust the audio delay from center channel from 0 to 5MS. -- SPEAKER SETUP PAG E -DO WNM IX CENTER REAR SUBWO O FER CNTR DELAY REAR DELAY TEST TO NE M AIN PAG E f. REAR DELAY Adjust the audio delay from center channel rom 0 to 15MS. The player is connected to a Dolby Digital amplifier through DIGITAL OUT Coaxial or Optical jack. The player is connected to a 2-channel digital mode or stereo amplifier through Coaxial or Optical jack. OP MODE -- AUDIO SETUP -SPDIF OUTPUT OP M ODE DUAL M ONO COM PRESSION PRO LOGIC LPCM OUTPUT M AIN PAGE LINE OUT RF REM OD LINE OUT : Line out mode with digital dialog normalization, compress input linear signal. Mix-mono can be functioned only if the DVD is playing in 5. Disc’s region code is not matching to the unit 4. Disc is not correct type to be played 5. Disc is damaged or dirty, clean the disc or try another disc 6. Moisture may be condensed inside the unit. Remove the disc and leave the unit power on for one or two hours No Picture 1. Check the TV set has been power on, and setting at the correct AV mode 2. check the system connection is secure 3. Check if the connection cables are damaged 4. Clean the disc Picture noise / distorted 1. Reset the color system of the DVD unit or the TV set 3. Try to direct the DVD unit to the TV set instead of via the components like VCR. [. . . ] Check if the MUTE function of the DVD, TV or amplifier has be activated 5. There will be no sound output during REVERSE PLAY / PAUSE / STEP / SLOW / SEARCH 25 5. Cannot read disc Pleasse see Fiugure4 e. Disc door cannot open Pleasse see Fiugure8 26 (i) Figure 1 START Power on The unit cannot switch on Does the connection between power board and the power cord/rear switch is correct? [. . . ]