User manual CME CONTROL 2 PLUS

[. . . ] ­ Red Green VCR Record Rewind Stop TV Fastext Func. White/Violet Blue Yellow ­ VCR Additional Func. Fast forward Pause Play The functions described above are only operative if your appliance also has them. FITTING THE BATTERIES Before programming and using the remote control, fit the batteries. The remote control requires 2 new AAA/LR03 alkaline batteries. [. . . ] Hold down the SHIFT and ON/OFF keys together until the TV or VCR selection key starts to flash indicating that the remote control is in programming mode. 1 0 3 5. Within 15 seconds, enter the code previously identified (e. g. Three flashes indicate that the code has been saved correctly. If not, try the code entry procedure again from point 3. B DIRECT CODE ENTRY FOR REMOTE CONTROLS VERSIONS V5 - V6 Warning: program one appliance at a time. 1. For VCRs, make sure a cassette has been inserted. In the code book enclosed, look for the brand of the TV or VCR appliance you want to control and make a note of the first code in the list BENEATH the brand previously identified (e. g. TV VCR Press and release the TV or VCR selection key for the appliance you want to use. You cannot set a VCR code using the TV key. Additional check Point the remote control at the TV or VCR. Check that the appliance responds correctly to the commands sent. If there is no response or the appliance only responds partially or incorrectly, it is probable that you have used the wrong code. In this case, try the procedure again from point 3. This time, however, use the NEXT CODE in the list (e. g. Make a note of the TV and VCR codes used to program the remote control on the adhesive label inside of the battery cover for rapid consultation. NOTE: THE TV OR VCR SELECTION KEY STOPS FLASHING. The remote control leaves the programming mode and the TV or VCR selection key stops flashing: · if no keys are pressed for 15 seconds · if an invalid brand code is entered · if you press the TV - VCR - F1 - F2 - F3 - F4 keys by mistake. 4. Hold down the SHIFT and ON/OFF keys together until the TV or VCR selection key starts to flash indicating that the remote control is in programming mode. 8 0 7 5 5. Release the keys and press the numeric key 8 once. Within the next 15 seconds, key in the three figure code you noted previously (e. g. Three flashes indicate that the code has been saved correctly. If not, try the code entry procedure again from point 3. C GLOBAL SEARCH REMOTE CONTROL PROGRAMMING This operation may take up to about 20 minutes. Warning: program one appliance at a time. 1. For VCRs, make sure a cassette has been inserted 2. [. . . ] SOLUTION Try some of the other frequently used keys. If the problem persists, check that the batteries are fitted correctly. If necessary, replace them with 2 new 1. 5 V AAA/LR03 alkaline batteries. Check that the batteries are new and that the remote control is pointing at the appliance without any obstacles in the way. [. . . ]