User manual CME XCORPIO V1.0

[. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used according to the instructions found in the users manual, may cause interference harmful to the operation of other electronic devices. Compliance with FCC regulations does not guarantee that interference will not occur in all installations. If this product is found to be the source of interference, which can be determined by turning the unit "OFF" and "ON", please try to eliminate the problems by using one of the following measures: Relocate either this product or the device that is being affected by the interference. Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter(s). [. . . ] Please note that you have to use the screws in the package. It may damage the electrical circuit of Xcorpio if you use other screw, and this kind of damage is not covered under warranty. Lock the screw into the small hole slightly on the back of Xcorpio first. Put the metal clasp on the indent on the back of Xcorpio and lock it with screw. Xcorpio User's Manual 5 You can lock the metal clasp in different directions. (see above) Connections of Xcorpio The design of Xcorpio is simple and clear, users can get familiar with it in a very short time. Below is the detail of Xcorpio's connectors. (Below the Xcorpio A is used as the example) 1. Line output, left channel (un-balanced, RCA, black) 3. Line output, right channel (un-balanced, RCA, red) 4. Headphone output LEDs, green one is for signal LED, red one is for clip LED. Left input channel LEDs, green one is for signal LED, red one is for clip LED. Right input channel LEDs, green one is for signal LED, red one is for clip LED. 6 Xcorpio User's Manual 8. Analog input jack, left channel (balanced, XLR, black) 9. Analog input jack, right channel (balanced, XLR, red) 10. USB port Installation and Un-installation of the Xcorpio Driver Note: Please do not connect Xcorpio to USB port of your computer before the setup program requires you to do so. Installing the Driver Please insert the driver CD of Xcorpio into the CD-ROM drive of your computer. The auto-run program will start up automatically. Click "Driver Installation or Un-installation" to begin the installation procedure. Note: The current installation program only supports English, so just click OK to start installation. Click the icon on the left of Install the driver to install driver. Xcorpio User's Manual 7 Select I accept the agreement then click Install. The Setup program will search to see if Xcorpio driver has already been installed. If it finds a previous driver, the setup program will un-install it first. It will take a moment, so please wait. The Setup program asks you to connect the Xcorpio to the computer. Please use a standard USB cable to connect Xcorpio and computer now. You do not need to click any button. 8 Xcorpio User's Manual Once connected the Setup program will initialize Xcorpio, which will take several minutes. Please wait. Please unplug Xcorpio from USB port of computer. The Setup program asks you to connect the Xcorpio again. [. . . ] (switchable by software) Adjustable gain for input channels up to +18dB, 0. 5dB per step. Different signal types selectable for each input channel. (Line In, Mic In, Guitar In) A stereo headphone output jack. (3. 5mm TRS) Headphone output volume control knob. [. . . ]