User manual COBRA ESD6100ML

[. . . ] ESD-6100. MANUAL. qx 10/23/98 3:45 PM Page 1 Installing and Using Your 1. What You'll Need To Install The ESD-6100: NOTE: Detailed instructions on opposite side 3. Turn On and Adjust Volume LEDs are briefly illuminated at Power ON F. Indicators and Visual Alerts Power Illuminates when On DETECTION SYSTEM Model ESDTM-6100 X Band Radar B. [. . . ] The VG-2 device detects low level energy radiated by the internal oscillators of radar detectors. The VG-2 device also radiates a similar type of energy. The ESD-6100 detects the VG-2's radiation before the VG-2 can detect the ESD-6100. The ESD-6100 then briefly turns off its internal oscillator, rendering it invisible to the VG-2, and alerts you to VG-2's presence. During these short intervals, the ESD-6100 is not able to receive radar or Safety Alert signals (laser reception is not affected). Once past the VG-2, the ESD-6100 returns to normal operation. G. Band Alarm Indicators When the Cobra ESD-6100 detects an X-band radar signal, the red "X" Visual Alarm Indicator (LED) will flash in unison with the X-Band audio tone. When the ESD-6100 detects either a K-band or a Ka-band radar signal, the amber "K/Ka" Visual Alarm Indicator will flash in unison with the K or Ka Band audio tone. When the ESD-6100 detects pulses of laser light, the yellow "L" LED will flash in unison with the Laser tone. When VG-2 is detected, the amber "VG-2" LED will flash with an audio tone. When a Safety Alert signal is detected, all LEDs except POWER will flash. Mute Button The mute function is controlled by a momentary button. Pressing MUTE will eliminate the audio during the alert in progress. The detector will automatically reset to normal operation after the alert has passed. It will also reset to normal any time the detector is turned off. City/Highway The Highway/City function is controlled by a 2-step momentary button. The Highway mode is automatically engaged when the unit is powered up. To engage City Mode, press down on the Highway/City button. A green LED will light to indicate that the detector is in City Mode. To reactivate the Highway Mode simply press down on the Highway/City button again. The green LED will go dark to indicate that the detector is in Highway Mode. The ESD-6100 will retain the chosen mode while off. [. . . ] If the unit is in warranty, upon receipt of your unit it will either be repaired or exchanged depending on the model. Please allow approximately 3 to 4 weeks before contacting us for status. If the unit is out of warranty a letter will automatically be sent informing you of the repair charge or replacement charge. If you have any questions, please call 773-889-3087 for assistance. Make check or money order (no stamps) payable to Cobra Electronics and mail with this order form to: Cobra Accessories Dept. [. . . ]