User manual COBRA ESD6200

[. . . ] ESD-6200. MANUAL. qx 10/23/98 3:48 PM Page 1 Installing and Using Your 1. What You'll Need To Install The ESD-6200: NOTE: Detailed instructions on opposite side 3. Turn On and Adjust Volume LEDs are briefly illuminated at Power ON F. Indicators and Visual Alerts Power VG-2 DETECTION SYSTEM Model ESDTM-6200 Illuminates when On Blinks at a steady rate Lights Up Safety Alert® Warnings B. [. . . ] When the ESD-6200 detects pulses of laser light, the yellow "L" LED will flash in unison with the Laser tone. When VG-2 is detected, the amber "VG-2" LED will flash with an audio tone. When a Safety Alert signal is detected, the pattern of signal meter will indicate that a Safety Alert signal is being received and which type it is. Mute/AutoMute Button Manual Mute: The mute function is controlled by a momentary button. Pressing MUTE will eliminate the audio during the alert. The detector will automatically reset to normal operation after the alert has passed. It will also reset to normal any time the detector is turned off. AutoMute: When in AutoMute the unit will reduce the audible sound by half after four seconds of the warning. Switching from AutoMute/Manual Mute: When no signal is present, pressing this button for less than 2 seconds will switch the unit between AutoMute Mode and Manual Mute. A double beep will confirm unit is in AutoMute and a single beep will confirm unit is in Manual Mute Mode. When in the Voice Mode, the ESD-6200 will announce "Auto Mute" or "Mute". Switching from Tone/Voice+Tone: When no signal is present, pressing the button for more than 2 seconds will switch the unit between Tone and Voice+Tone Mode. A "Voice Alert" will confirm Voice+Tone has been selected and a single beep will confirm that Tone Only Mode has been selected. "Be Careful. . . " Safety Alert Warnings: "Emergency Vehicle Approaching" "Road Hazard Ahead" "Train Approaching" The message "Be Careful. . . " and the Voice Alert Message will sound at the start of the alert. The Voice Alert Message will be followed by the corresponding Tone Alerts. See Section H for turning off the Voice Mode. Instant-on Detection The Cobra ESD-6200 is also designed to detect Instant-on speed monitoring signals. Immediate action is required when warning is given. I. City/Highway The Highway/City function is controlled by a 2-step momentary button. The Highway mode is automatically engaged when the unit is powered up. To engage City Mode, press down on the Highway/City button. A green LED will light to indicate that the detector is in City Mode. To reactivate the Highway Mode simply press down on the Highway/City button again. [. . . ] COBRA shall not be liable for any incidental, consequential or other damages; including, without limitation, damages resulting from loss of use or cost of installation. Some states do not allow limitations on how long an implied warranty lasts and/or do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations may not apply to you. Cortland Street, Chicago, Illinois 60707 55 Illinois residents add 7% 55 Cook County, ILresidents additional . 75% (7. 75% total) 55 Chicago, ILresidents additional 1% (8. 75% total) 55 Indiana residents add 5% 55 Michigan residents add 6 % 55 Ohio residents add 6% 55 Wisconsin residents add appropriate % Amount __________ (Tax if applicable) __________ Shipping/handling Total @ $3. 75 __________ Make check or money order (no stamps) payable to Cobra Electronics and mail with this order form to: Cobra Accessories Dept. [. . . ]