User manual COBRA XRS 9345

[. . . ] Introduction Intro Important Information and Customer Assistance Operation Customer Warranty Assistance Important Information Federal Laws Governing the Use of Radar Detectors It is not against federal law to receive radar transmissions with your Cobra radar/ laser detector. The Communications Act of 1924 guarantees your right to receive radio Secondary Icons transmissions on any frequency. Local laws that contravene this Act, while illegal, may be enforced by your local law enforcement officials until and unless they are prohibited from doing so by federal court action. Operating Instructions Safety Alert Use of this product is not intended to, and does not, ensure that motorists or passengers will not be involved in traffic accidents. [. . . ] Notice Tone Two beeps Visual Display None Main Icons Main Icons n Icons X K Ka V S Intro Operation Customer Assistance Notice c Warranty X K Ka V S c Intro Operation Warranty If, for any reason, the unit stops sensing your engine's revs, IntelliMute will indicate an error and automatically turn Off. Intro ondary Icons Operation Customer Warranty The rev Assistance you set will be stored in the unit's memory when point power is turned Off and recalled each time the power is turned On. NOTE The rev point must be reset if you use your detector in a different vehicle. Notice Rev yourMain Icons to engine None the level you wish to set (recommend slightly above idle) and hold revs steady for two seconds. Intro Operation Three bars will flash in succession Intro Operation Customer Assistance Warranty Customer Assistance Installation Customer Assistance 1 Secondary Icons Main Icons Installation 2 Customer Secondary Icons Assistance 3 Notice Caution Warning Warning Main Icons Notice Caution ondary Icons Operation NOTE When initially choosing your IntelliMute activation point, a setting Notice of approximately 300 to 600 RPMs above idle is recommended. Warranty Customer Assistance You can reset the activation point at any time to fit your individual preferences and driving style. Setting the IntelliMute Activation Point Customer Assistance Your detector must be installed in your vehicle. CAUTION Do not attempt to set the rev point while driving. Your vehicle should be parked and idling. Warning At the desired rev level, press and release the IntelliMute button. Secondary Icons Three beeps Customer Assistance Warranty All three bars flash three times Intro Operation Intro Customer Assistance Warranty Operation Customer Assistance Warranty 1 Secondary Icons Installation 2 Customer Assistance Secondary Icons Installation 3 Customer Assistance Notice Caution Warning Notice Caution Warning Notice Installation NOTE If the unit is unable to sense usable pulses within three seconds or if you do not set a rev point within 20 seconds of beginning these steps, IntelliMute will indicate an error and automatically turn Off. Tone Four beeps Visual Display E appears Notice Caution IntelliMute must be turned on before setting the activation point. You will hear a series of beeps as you follow the steps on the next page. X K Ka V S E 10 English Nothing Comes Close to a Cobra® 11 Your Detector Intro Operation Settings Customer Warranty Your Detector Intro Operation Settings Customer Warranty Assistance IntelliMute Pro Assistance VG-2 and Spectre I & IV+ Alert Settings IntelliMute Pro prevents detection by radar detector detectors (RDDs) such as VG-2, Spectre I and Spectre IV+ when traveling at slower speeds. It is intended for use by experienced users only. OperationSecondary Icons Customer Assistance When IntelliMute Pro is turned On, and engine RPMs are below the IntelliMute activation point, your detector's radar detection circuits are turned Off to prevent detection by RDDs. Assistance Before IntelliMute Pro can be turned On, you must have turned On and Set the IntelliMute activation point. (See pages 9 through 11. ) Notice Customer Warranty Police use radar detector detectors (RDDs) to spot users of radar detectors. Your detector is able to identify signals from VG-2, Spectre I and Spectre IV+ RDDs and can provide alerts when any of these or similar devices are in use Secondary Icons your vehicle. near Your detector can be spotted by Spectre IV+ RDDs, but is invisible to VG-2 and Spectre I RDDs. You can choose whether you want to be alerted to VG-2 and Spectre I & IV+ RDD signals. The factory setting for VG-2 and Spectre I & IV+ alerts is Off. Notice Installation On/Off Indicator Notice Caution CAUTION When IntelliMute Pro is On, NO radar signals will be detected and NO alerts will be given at RPMs below the IntelliMute activation point. Warning IntelliMute Button City Button Press and hold both buttons simultaneously IntelliMute Pro On X K Ka V S c Dim Button Press and hold for four seconds To Turn VG-2 and Spectre I & IV+ Alerts On and Off While no signal is being Tone detected, press and On = Two beeps hold the Dim button for four seconds. Off = One beep Visual Display V will blink twice in the display V will blink once in the display X K Ka V S c Pop Alert The Pop Mode Radar Gun is a single-pulse Doppler radar that is a feature of a K and Ka (Bee III Ka radar gun) band Instant-On radar gun. It uses a single, short-time pulse to measure the target vehicle's speed. To Turn IntelliMute Pro On While no signal is being detected, press and hold both the IntelliMute and City buttons for four seconds. Tone Two beeps Visual Display c or h will blink The Pop mode receiver senses Pop singles beyond the effective range of Pop radar guns. As the Pop mode receiver is so sensitive, you should limit the use of Pop Detect mode to highway and rural driving. Pop Alert will alert you to Pop radar signals. During the alert, the unit continues to detect other signals. [. . . ] If this product should require factory service, please call Cobra first at 773-889-3087 BEFORE sending the product. This will ensure the fastest turnaround time on any repair. Notice · Secondary Icons Notice Cobra will, without charge, repair or replace, at its option, defective 14 Band Radar/Laser Detectors, products or component parts upon delivery to the Cobra Factory Service Department, accompanied by proof of the date of first consumer purchase, such as a duplicated copy of a sales receipt. You must pay any initial shipping charges required to ship the product for warranty service, but the return charges will be at Cobra's expense, if the product is repaired or replaced under warranty. This warranty gives you specific rights, and you may also have other rights which vary from state to state. [. . . ]