User manual COBRA XRS 9645 QUICK START GUIDE

[. . . ] Introduction Intro Important Information and Customer Assistance Operation Customer Warranty Assistance Important Information Federal Laws Governing the Use of Radar Detectors It is not against federal law to receive radar transmissions with your Cobra radar/ laser detector. The Communications Act of 1924 guarantees your right to receive radio Secondary Icons transmissions on any frequency. Local laws that contravene this Act, while illegal, may be enforced by your local law enforcement officials until and unless they are prohibited from doing so by federal court action. Operating Instructions Safety/Strobe Alert Use of this product is not intended to, and does not, ensure that motorists or Notice passengers will not be involved in traffic accidents. [. . . ] At the desired rev level, press and release the Set/City button. Press and release either the Select/Dim button Warranty to proceed to the Customer Assistance next user mode or the Program/Mute button to exit the Program mode. None ondary Icons Operation NOTE When initially choosing your IntelliMute activation point, a setting Notice Customer of approximately 300 to 600 RPMs above idle is recommended. Warranty Assistance You can reset the activation point at any time to fit your individual preferences and driving style. Customer Setting the IntelliMute Activation Point Assistance Your detector must be installed in your vehicle. Intro Operation Setting IntelliMute RPMs Secondary Icons Set Intel. . . Press SET. . . Intelli Mute Set! Installation Notice Caution CAUTION Do not attempt to set the rev point while driving. Warning Your vehicle should be parked and idling. Notice NOTE If the unit is unable to sense usable pulses within three seconds or if you do not set a rev point within 20 seconds of beginning these steps, IntelliMute will indicate an error and automatically turn Off. Tone One beep One beep Visual Display IntelliMute not set Please try again IntelliMute Off IntelliMute Not Set IntelliMute must be turned On before setting the activation point. IntelliMute Off Intelli IntelliMu. . . Off Nothing Comes Close to a Cobra® 15 14 English Your Detector Intro Operation Settings Customer Warranty Main Icons Your Detector Intro Operation Settings Customer Assistance Warranty Assistance IntelliMute Pro Compass Intro Operation N NW 8-Point Compass IntelliMute Pro prevents detection by radar detector detectors (RDDs) such as VG-2, Spectre I and Spectre IV+ when traveling at slower speeds. It is intended for use by experienced users only. OperationSecondary Icons Customer Assistance When IntelliMute Pro is turned On, and engine RPMs are below the IntelliMute activation point, your detector's radar detection circuits are turned Off to prevent detection by RDDs. Before IntelliMute Pro can be turned On, you must have turned On and Set the IntelliMute activation point. (See pages 13 through 15. ) Notice CAUTION When IntelliMute Pro is On, NO radar signals will be detected and NO alerts will be given at RPMs below the IntelliMute activation point. Warning Warranty Your detector includes an internal Customer Warranty Assistance 8-point Compass that will continuously display your current direction of travel: Secondary Icons N, NE, E, SE, S, SW, W or NW. NE W SW E SE Secondary Icons Installation Customer Assistance Calibrating the Compass S Notice NOTE Notice Before using it for the first time, you must calibrate the compass to provide accurate indications of direction. See page 7 for instructions on using the Program mode to select Set Compass. Calibration allows the compass electronics to measure and store information about the magnetic fields generated by your vehicle. Notice Caution Main Icons To Turn IntelliMute Pro On or Off Using Program Mode (See Page 7 For Instructions on Using Program Mode) In Program mode, go to IntelliMute Pro. Tone Two beeps One beep Visual Display IntelliMute Pro On, then i blinks in the display IntelliMute Pro Off, then i is steady in the display Secondary Icons Intro The compass will remain accurately calibrated as long as your detector is mounted in the same place in your vehicle. If you change the location where the unit Customer is mounted or move it to another vehicle, you must recalibrate the Warranty Operation Assistance compass. The compass temporarily may not provide accurate readings if you are inside a building or enclosure, or are close to a large metal tractor/trailer, truck, or train. Once you are away from such a location, the compass will work correctly again. NOTE When the instructions direct you to drive in two circles, a large parking lot is the most convenient place to do so. It does not matter what direction your vehicle is pointing when you start the circles, which direction you go to make the circles, and it does not have to be exactly two circles. You do NOT have to make perfect circles. You can drive in any pattern, as long as you make two complete turns. Four three-point turns, two small squares, or any two complete loops will work as well as two circles. It does not matter what size the circles are, if your speed is constant, or how fast you make the circles [but less than two minutes]. Please be careful when making the circles and watch for other traffic. IntelliMute Pro On IntelliMute Pro Off Intelli Mute Pro On NW ih Intelli Notice Mute Pro Off NW ih 16 English Nothing Comes Close to a Cobra® 17 Your Detector Intro Operation Settings Customer Assistance Warranty Your Detector Settings Customer Assistance Warranty Pop Alert Set/City Button Intro Operation Select/Dim Button Secondary Icons Program/Mute Button To Calibrate the Compass Using Program Mode (See Page 7 For Instructions on Using Program Mode) In Program mode, go to Notice Set Compass. [. . . ] If this product should require factory service, please call Cobra first at 773-889-3087 BEFORE sending the product. This will ensure the fastest turnaround time on any repair. Notice · Secondary Icons Notice Cobra will, without charge, repair or replace, at its option, defective 15 Band Radar/Laser Detectors, products or component parts upon delivery to the Cobra Factory Service Department, accompanied by proof of the date of first consumer purchase, such as a duplicated copy of a sales receipt. You must pay any initial shipping charges required to ship the product for warranty service, but the return charges will be at Cobra's expense, if the product is repaired or replaced under warranty. This warranty gives you specific rights, and you may also have other rights which vary from state to state. [. . . ]