User manual COBRA XRS 9970G

[. . . ] Introduction Important Information and Important Information Federal Laws Governing the Use of Radar Detectors 15 Operating Instructions It is not against federal law to receive radar transmissions with your Cobra radar/ laser detector. The Communications Act of 1924 guarantees your right to receive radio transmissions on any frequency. Local laws that contravene this Act, while illegal, may be enforced by your local law enforcement officials until and unless they are prohibited from doing so by federal court action. Safety/Strobe Alert Use of this product is not intended to, and does not, ensure that motorists or passengers will not be involved in traffic accidents. [. . . ] The signals will remain muted for as long as the signal is detected. When Auto Mute is Off, the alerts will sound at Secondary Icons full volume for as long as the signal is detected. Voice or Tone Mode You can set your detector to sound alerts and confirm menu settings with either a Voice or a Tone Alert. Voice Alert provides voice messages in addition to tones. Tone AlertNotice provides tones only. Notice At the Set Point screen: 1. Press and hold the vehicle accelerator at the desired engine RPMs. Press the center icon on the touchscreen to complete the setting process. The system will store the engine RPM setting and provide a completion message. This Activation Point will be recalled each time the power is turned On. The Activation Point can be changed at any time by following the same procedure used to set it initially. Changes to the Activation Point can also be made by Pressing the IntelliMute icon on the main standby screen when either IntelliMute or IntelliMute Pro is On. This will immediately bring up the IntelliMute Set Point setting screen. NOTE If the unit is unable to sense usable pulses or if you do not set a rev point within 30 seconds of beginning the setup, an error will be indicated. If you do not try again within five seconds, the setup process will automatically turn Off. The unit will provide corresponding messages for these conditions. If, for any reason, the unit stops sensing your engine's revs, IntelliMute or IntelliMute Pro will automatically turn Off and the icon will change to show the Off condition. NOTE The rev point must be reset if you use your detector in a different vehicle. NOTE When initially choosing your IntelliMute or IntelliMute Pro Activation Point, a setting of approximately 300 to 600 RPMs above idle is recommended. 22 Customizable Display Colors Your detector includes the Color Theme feature that allows you to customize the Display Screen Color scheme to match your car's dash illumination: Multi-Color, Red, Blue, Orange or Green. Display Timeout Display Timeout determines how long the Standby screen is illuminated before switching the unit to Dark. You can set the time interval to 15 seconds, 30 seconds, one minute, three minutes or Always On (display never turns Off). Click the plus (+) and minus (-) icons to change the settings. Frequency Display Mode Different Ka radar and LIDAR (Laser) guns operate at various frequencies within their assigned spectrums. When Frequency Display is turned On, the signal frequency will be added to the alert. English Nothing Comes Close to a Cobra® 23 Your Detector Intro Operation User Settings Customer Warranty Your Detector Intro Operation Alert Settings Customer Warranty Assistance Your detector includes the SmartPower feature that, when turned On, will put the unit into Low Power mode 15 minutes after the car's engine has been turned Off. Assistance Alert Settings Before SmartPower enters Low Power mode, you will hear three beeps and SmartPower will flash on the display. To return the unit to Normal Power mode and Secondary Icons exit Low Power mode, start the car, click anywhere on the touchscreen or turn the unit Off and then On again. From the Restore Factory Settings screen, you can quickly and conveniently restore your detector to its original settings. [. . . ] If the originals are sent, they cannot be returned; 2. Enclose a description of what is happening with the product. Include a typed or clearly printed name and address of where the product is to be returned, with phone number (required for shipment); 4. Pack product securely to prevent damage in transit. [. . . ]