User manual COMCAST CUSTOM DVR 3-DEVICE

[. . . ] Press Mute once to turn sound off or on. In the Cable mode, press FAV once to display programmed favorite cable channels. Use CH+ (or CH-) to select the next higher (or lower) channel. When controlling a DVD player, use CH+ (or CH-) to skip forward (or skip reverse) through video. [. . . ] For example, after trying all of the codes for your TV, you still cannot get the remote control to operate your TV, then: 1. Then press and hold Setup until the TV key blinks twice, then release Setup. Aim the remote control at the the TV and slowly alternate between pressing Power and TV. A working code has been found. NOTE: In the search mode, the remote control will send IR codes from its library to the selected device, starting with the most popular code first. 2. PROGRAMMING DEVICE CONTROL The Comcast Custom 3-Device universal remote control is preprogrammed at the factory to operate the Cable Box supplied by your Comcast system, an RCA TV, and an RCA VCR (in the AUX mode). To control devices other than default brands (excluding the Cable Box), perform the below steps; otherwise skip this section: 1. Turn on a device (e. g. , VCR or DVD Player) and, if applicable, insert media, (e. g. , video cassette or disc). NOTE: Please read steps 2 to 6 completely before proceeding. Highlight or write down the codes and device you wish to program before moving on to step 2. 3. TROUBLESHOOTING PROBLEM: A mode key does not blink when you press a key. SOLUTION: Replace the batteries with two (2) new AA batteries. PROBLEM: During programming, a mode key displays one long blink. SOLUTION: An invalid entry has occurred. Check the key to be entered and try programming again. PROBLEM: A mode key blinks when you press a key, but home entertainment component does not respond. SOLUTION: Make sure the remote control is aimed at your home entertainment device and is not farther than 15 feet away. PROBLEM: The remote control does not control home entertainment devices or the commands are not working properly. SOLUTION: Try all listed codes for the device brands being set up. Make sure they can be operated with an infrared remote control. PROBLEM: CH+, CH-, and Last do not work for your RCA TV. SOLUTION: Due to RCA design (1983­1987), only the original remote control will operate these functions. PROBLEM: Changing channels does not work properly. SOLUTION: If original remote control required pressing Enter to change channels, also press Enter on this remote control after entering the channel number. Device Type:______________ TV Code: User Guide OVERVIEW The Comcast Custom DVR 3-Device universal remote will control up to three home entertainment devices, including a Digital Video Recorder enabled Cable Box (used by Comcast Systems). The remote control requires installing two (2) new AA batteries (included) and some easy programming to control your devices. For best results, please read and perform all instructions listed here. [. . . ] Then press and hold Setup until the TV key blinks twice, then 5. 2. 5. PROGRAMMING CHANNEL CONTROL LOCK By default, the remote control's channel-control capabilities are locked to the Cable Box. The affected keys are 0 ~ 9, CH+, CH-, Enter, and Last. This will guarantee that you do not inadvertently change a channel while in the TV mode. [. . . ]