User manual COMET LABS MGB100

[. . . ] MGB100 Portable Wireless AP Storage USER MANUAL English Version Ver. 1. 1 Copyright The contents of this publication may not be reproduced in any part or as a whole, stored, transcribed in an information retrieval system, translated into any language, or transmitted in any form or by any means, mechanical, magnetic, electronic, optical, photocopying, manual, or otherwise, without the prior written permission. Trademarks All products, company, brand names are trademarks or registered trademarks of their respective companies. They are used for identification purpose only. [. . . ] Status: to show the current wireless mode you are using. Wireless mode description: to describe the each wireless mode's major function. Wireless modes selection: MGB100 provides four wireless modes to select. 39 Choose the wireless mode you need and click "Go" to set up detail functions. 3. 2. 2. 1 Wireless AP only When you are in the AP only mode, you can set up the basic wireless functions as below: 40 AP setting: SSID: The SSID identifies a specific wireless LAN. Before associating with a particular wireless LAN, a station must have the same SSID as the access point. The default SSID setting is "MGB100". NOTE: Please DO NOT set the same SSID with your current wireless network. NOTE: Please DO NOT set the same Channel with your current wireless network. Authentication: Authentication ensures that digital data transmissions are delivered to the intended receiver. This option enables you to set 41 the authentication method for various encryption schemes for the selected AP. Open or shared WEP Encryption: Select "64" or "128" bits in the pull-down menu for encryption method to protect your data by encrypting it. The WEP key can be 5~13 ASII characters or 10~26 hexadecimal characters based on whether you select 64 bit or 128 bit WEP encryption. 802. 1X: IEEE802. 1x authentication can be done by using an external RADIUS server. Please input the IP address of RADIUS server and Shared Secret. Please refer to FAQ in Chapter 7 to get more detailed information. WPA-PSK: AP and Client need to use identical Pre-shared key (PSK). Please input 64 Hex key (0~F) or 8~63 characters in ASCII Type. This device only supports WPA version 1. WPA: WPA applies IEEE802. 1x and Extensible Authentication Protocol (EAP) to authenticate wireless clients using an external RADIUS server. 42 Please input the IP address of RADIUS and Shared Secret. Please refer to FAQ in Chapter 7 to get more detailed information. Advance Setting: 43 Wireless mode: 11b/g mixed can let 11g or 11b computers both exist on the network, but the speed will be reduced. Select 11g only for maximum speed, but no 11b users will be allowed on the network. Beacon interval: This represents the amount of time between beacon transmissions. The interval tells receiving devices on the network how long they can wait in low-power mode before waking up to handle the beacon. [. . . ] Disable the wireless connection and enable again. The DUT will send the user' certificate to the RADIUS server, and s then send the message of authentication result to PC2. Windows XP will prompt that the authentication process is success or fail and end the authentication procedure. Terminate the test steps when PC2 get dynamic IP and PING remote host successfully. 74 Problems of security level 1. [. . . ]