User manual COMPRO IP50W INSTALLATION

[. . . ] VideoMate IP50/50W Network Camera Installation Guide Compro Technology, Inc. www. comprousa. com Table of Contents IP50 / 50W Network Camera Hardware Layout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Assembly and Disassembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Mounting: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] On page 1 of the Wizard, you can set the basic setting of the camera, including name, time, port and frequency. Please note, the default value should be used for the best performance. The "Utility Frequency" represents the frequency of your local mains power. 13 11. The default setting is for the IP camera to obtain IP address automatically via LAN connection. 12. To use the wireless network as the primary connection, please tick the "Use the wireless network as the primary connection" option. 14 13. Once all of the previous settings had been done, please press the "Finish" button to finalize the setup of this particular camera. You will need to follow all of the above processes should you wish to set another one. Note: It takes around 1 minute for the camera to apply the setting and operational. 15 Using the IP Camera: Compro Technology provides a range of access method to access and using the IP camera that you've just installed. 4 1 3 2 1. Accessing a single camera via the Internet Explorer which is found on all Windows system. This is the easiest way of using the IP camera and requires little learning of the software. Accessing a single camera or multiple cameras via the ComproView Mobile client available on Windows Mobile 5 and 6 smart phones. The current supported resolutions are 320 x 240 and 640 x 480. Accessing a single camera via 3GPP capable phone over the internet. This is the preferred way of monitoring your camera when you are out of the house and have no access to a computer. However, due to the limitation of the technology, only video stream is provided in this mode. Do keep in mind that your mobile phone network service provider will be charging a pre-determined rate for using this service. Access a single camera or multiple cameras via the bundled ComproView software. ComproView is a comprehensive software encompassing the monitoring, recording and detection of the set area. For the full function of the ComproView, please refer to the electronic manual included on the CD. 16 Web Browser Access (Internet Explorer): User can monitor the current condition of the monitor area via Internet Explorer which is found on all Windows based machine. Enter the IP 50 / 50W's IP address. User will see the dialog to request the user name and password; please enter the valid username and password of IP camera, and then press OK. The default user name and password is "admin". 17 4. [. . . ] After IP Camera device is decided, the following option could let user to change "Manufacture", "Model", "Format", "Frame Rate", "Resolution", "Compression", "Rotation", "Enable Audio", "Enable IO", and "Enable PTZ". After all the selections are ready, presses the OK button to close the IP Camera setting. Upon IP Camera Setup is completed, please press "Apply" button to Memorized the setting and then press "OK" button to close the setup dialog. After the IP camera setting is completed, please wait a while for connection. [. . . ]