User manual CONCORD 170BV NEW

[. . . ] · Protect those parts of the CONCORD TRANSFORMER that are not covered in fabric from direct sunlight to avoid your child being burned. · The child restraint system must not be damaged or trapped by moving parts in the car interior or by doors. · Never modify the CONCORD TRANSFORMER in any way ­ this will endanger your child's safety. 25 24 · After an accident the CONCORD TRANSFORMER must be replaced or returned to the manufacturer for testing, along with a report of the accident. [. . . ] There you will also be able to buy the full range of accessories for CONCORD child car seats. The buckle of the vehicle safety belt must not come above the edge of the lap belt guide. If in doubt or if you are still uncertain, please contact CONCORD. The belts may only be routed via the points of contact and the positions on the seat stated in the user instructions. Belts must not be routed in any other way. If the car seat used has a front airbag, we recommend positioning the car seat as far back as possible. For cars with front and side airbags, the instructions in the car's operating manual must also be observed. The car's shoulder/diagonal belt must pass forwards from the vehicle bracket to the shoulder belt guide (07). Adjust the car seat position if necessary. 27 _USINGTHECONCORDTRANSFORMER You have decided to purchase our CONCORD TRANSFORMER seat for the safety of your child. This product is manufactured under strict quality controls. It can only effectuate its maximum safety properties if it is used properly. It is important to ensure that the belts are always correctly positioned each time the seat is used. If in doubt about any aspect of fitting, check with CONCORD. The belts must pass through the guides marked in red on the seat. Belts must not be routed in any other way. _ADJUSTINGTHEINCLINATION To use the inclination adjuster on the CONCORD TRANSFORMER, press the seat inclination button (04) on the front edge of the seat. Keeping the button pressed, move the seat into the required position. The inclination of the CONCORD TRANSFORMER is continuously adjustable and is locked into the current position when the seat inclination button (04) is released. 32 33 _CAREINSTRUCTIONS The cover can be removed for washing. To do so, move the head section (01) to its highest position. To remove, pull the cover away from its anchoring points. Begin by removing the head section (01) followed by the seat section and the shoulder shields (02). To replace, start with the cover for the seat section. First pull the cover over the cover panel on the backrest. [. . . ] The guarantee period corresponds to the statutory warranty period in the end-user's country concerned. At the manufacturer's discretion, the guarantee shall cover rectification, replacement or a price reduction. The guarantee is valid for the original purchaser only. In the event of any defect, claims can not be considered unless the specialist dealer is notified of the fault as soon as it occurs for the first time. [. . . ]