User manual CONCORD 370 AF

[. . . ] Pull out the film leader to reach the film tip mark (17). Ensure the tip of the film leader is hooked on the film take up spool (15) teeth. Press the shutter release button (2) down once to advance the film. [. . . ] Slide the lens cover switch (4) to open the lens cover. Frame your object in the viewfinder (5) and keep a distance of at least 1. 5meters (5 feet) between the object and the camera. Before you press the shutter release button (2), hold your breath and press the button gently and firmly. After you press the shutter release button (2), the camera will advance automatically to the next frame. Flash will be automatically turned on in low lighting condition (ISO 100 below EV 11. 5). We recommend using ISO 400 film in the flash mode. Note: When the sun or any bright light source is behind the object, it acts as a backlight and causes faces to appear dark in the pictures. Better results are to be obtained if fill-in flash is used. To take picture with fill-in flash, hold the fill-in flash button (7) in until the flash ready indicator (9) is fully illuminated. Then press the shutter release button (2) to take a picture. Note: To take picture indoor where flash is prohibited, press and hold the flash off button (21). Then press the shutter release button (2) to take a picture and the flash will not go on. Specifications Type: Film format: Lens: Focusing: Focusing range: Exposure setting: Film loading: Film advance: Film rewind: Film speed setting: Exposure counter: Flash: Flash operating range: 35mm auto focus camera with built-in flash 24mm x 36mm 28mm f/5. 6 3 group 3 element lens 2 steps auto focus 1. 5m ~ (infinity) 1/100 sec. , f/5. 6 Easy loading Auto wind, stop automatically at the end of film Power film rewind with manual rewind switch DX automatic setting (ISO100/400) Mechanical additive counter Built-in sensor auto flash ISO100: 1. 5m ­ 2. 5m ISO200: 1. 5m ­ 4. 0m ISO400: 1. 5m ­ 5. 0m Approx. 5s (with fresh AA alkaline batteries) Green ­ flash ready Reverse Galilean type viewfinder Uses 2 AA alkaline batteries Shutter release button locks when lens door closed 120mm (W) X 72. 5mm (H) X 43mm (D) Approx. 186g (without film and batteries) Film unloading 1. The film will stop automatically after the last frame is exposed. Slide the film rewind switch (19) right to the end in the direction of the triangular mark shown. The switch then locks in the position and the film will be rewound automatically. The motor will stop after the film is completely rewound. [. . . ] With the batteries removed, store your camera away from heat, moisture or direct sunlight. Never leave your camera or film in car or in damp closet. Specifications subject to change without further notice. Guide to use your camera Inserting batteries 1. Pull battery compartment door (18) with forefinger in the direction of the triangular mark on the cover to open the battery compartment. [. . . ]