User manual CONCORD ISOFIX BASE CAR FITTING LIST 06-2009

[. . . ] Tohelpyourbabygrowcorrectly, weadvisethatyoudo not over-use the safety seat on long journeys, and that you frequently lay them stretched out in a Moses basket or bed. Always keep it in its compartment under the safety seat. Makesurethatinsidethecar, luggageandanyother object likely to cause harm in an accident are correctly fastened or stored. TheCONCORDISOFIX BASEsafetyseatmustbefastened correctly with the seat belts or ISOfix base, even if it is not in use, as it could be thrown around in an accident and harm the occupants of the car. [. . . ] You will need to check this with the car manufacturer or seller. AnychangesoradditionstotheCONCORDISOFIX BASE without the correct authorisation from CONCORD may seriously affect the safety of the restraining system. Notfollowingtheinstructionsonhowtousethe restraining system may endanger your baby`s safety. Thissafetydevicecannotbeusedwithoutitscover, or replaced with one that is not the original, as it is an integral part of the system`s safety features. Your CONCORD ISOFIX BASE safety seat has been designed with the latest safety developments in mind and has been tested under the toughest conditions. it has the following features: Installation in cars: · Slotforpassingbeltsthroughunderthebodyoftheseat that enables it to be installed in cars with shorter seat belts. Install the seat in your car with a simple click and no need to thread seat belts through. Comfort and safety for your baby: · Recommended for the first few months when a sitting position makes it difficult for the baby to breathe. Impact-absorbentmaterialontheentiresurfacethat comes into contact with the baby. Avoid difficulties in installing and uninstalling straps when you need to change the height of the seat belts. Choosing the right place where you want to install the safety seat in the car will reduce the risk of injury to your baby in the event of an accident. Put the baby in the safety seat, making sure that they are sitting back in it and that their back is straight. Insert them in the fastener and press until you hear a click. Your CONCORD ISOFIX BASE carrycot can be fastened to any CONCORD chassis that has the PRO-FIX system. To release your CONCORD ISOFIX BASE from the chassis, press the switch (11) on the handle and pull the seat upwards. To fasten the safety seat to a chassis, insert the connections in the cavities on the chassis and press until you hear a click. Do not expose the cover to extended periods of sunlight. While the seat is not in use, cover it or store it in the boot. Wash the plastic parts in warm soapy water and dry all the components thoroughly. The cover can be removed for washing for which you should follow these instructions: Casing cover. remove the 6 elastic bands and clasps under the edge of the casing. Pass the clasp that goes between the legs through the buttonhole. [. . . ] Remove the cover from the tightener button area and finally undo the Velcro on the central part and remove the cover upwards. First remove the cover on the headrest skirt. Follow the same procedure but in reverse to put the cover back on. The warranty shall commence from the time at which the seat is purchased. [. . . ]