User manual CONSTRUCTA CE207N00

[. . . ] CE. . N. . jklkj<ycxkjölyxkjcöyxkjcökyxjcölyxjj ölkjdlfkjlsdkjflsdkjflksdjflksdjflksdjf lkjdlfksdjflksdjflkjsdflkjsdflkjsdlfkjsdlkdjf lkjsdflksjdflksjdflkjsdlfkjsdlkfjsldkfjsldkjf lkjsdflkjsdflkjsdlkfjsldkfjlsdkjflskdjflskdjfl< lkasjdlaskjdlaskjdlkasjdlkasjdlkajsdlaksjd lkasjdlaskjdlaskjdlaskjdlaskjdalksdjlaskj lkjsdlfkjsldkjflskdjflsdjflksdjflsdkflsdkfj 2-6 4-8 6 - 12 en Operating instructions 9000 577 017 (9007) en Index Information concerning disposal . Note ambient temperature and ventilation . Switching off and disconnecting the appliance . Defrosting and cleaning the freezer compartment . [. . . ] Changing over the door handles Lever handle Fig. Carefully place the appliance on its back. Note ambient temperature and ventilation The climatic class can be found on the rating plate. It specifies the ambient temperatures at which the appliance may be operated. The rating plate can be found inside the appliance at the bottom left hand side. Climatic category SN N ST Permitted ambient temperature +10 °C to 32 °C +16 °C to 32 °C +16 °C to 38 °C +16 °C to 43 °C Your new appliance Fig. 1 1 Temperature selector 2 3 4 5 6 7 Freezer compartment flap* Freezer shelf Large freezer drawer Freezer drawer Door compartment for ice blocks Height adjustable feet T Ventilation Fig. 6 The air at the back of the appliance will heat up. This warm air must be allowed to freely escape, otherwise the refrigerating machine must perform more. Hence, the air inlet and outlet apertures should never be covered or blocked off! *not all models 7 en Connecting the appliance After installing the appliance, wait at least 1 hour until the appliance starts up. During transportation the oil in the compressor may have flowed into the refrigeration system. Before switching on the appliance for the first time, clean the interior (see Cleaning). Connect the appliance to 220-240 V/ 50 Hz alternating current via a correctly installed earthed socket. The socket must be fused with a 10 A to 16 A fuse. If the appliance is to be operated in a non European country, check on the rating plate whether the indicated voltage and current type correspond to the values of your mains supply. The rating plate is situated in the bottom left hand side of the appliance. The power cord may be replaced by a technician only. Switching on the appliance Rotate the temperature selector Fig. 2/2 comes on. Selecting the temperature Rotate temperature selector Fig. Higher settings denote lower temperatures in the freezer compartments. We recommend a medium setting. Operating tips S The sides of the housing are sometimes heated slightly. This prevents condensation in the area of the door seal. S If you cannot open the freezer compartment door immediately after closing it, wait 2 3 minutes until the partial vacuum has equalised. S The refrigeration system may cause several areas of the freezer shelves to frost quickly. [. . . ] Water used for cleaning must not drip into the control panel. 12 en Tips for saving energy S Install the appliance in a cool, well ventilated room, but not in direct sunlight and not near a heat source (radiator, cooker, etc. ). S Allow warm food and drinks to cool down outside the appliance. S When thawing frozen food, place it in the refrigerator compartment. The low temperature of the frozen food will then cool the food in the refrigerator compartment. [. . . ]