User manual CONSTRUCTA CG540J2

[. . . ] en Instructions for use 9000 193 515 (8606) en Index 4 6 7 8 9 10 11 13 Programme overview . 16 17 18 19 21 24 25 25 27 Safety instructions . . en Safety instructions Delivery Immediately check the packaging and dishwasher for any damage which may have been caused in transit. Do not use a damaged appliance, but consult your supplier. [. . . ] In order to resume the programme, set the main switch to ON again. 17 en Terminating the programme (Reset) Only when the main switch is on: Rotate programme selector to the Reset position. When the programme has run, switch off the main switch 1 . To restart, rotate the programme selector 3 to the required programme. The programme sequence starts automatically. Additional functions * * on some models additional functions 4 can be set with the buttons. Pre-Soak * The Pre-Soak programme option serves to perform a pre-soak cycle before the main programme. to be pre-soaked and pre-rinsed in the lower rack. If you wish to pre-soak the dishes, this programme option must be selected by pressing the "Pre-Soak" button before the programme starts. The recommended detergent amount is approx. 5 g poured onto the inside of the door. Changing the programme It is possible to change the programme within 2 minutes after you have switched the dishwasher on. Should it be necessary to change the programme after this period, the programme cycle that has already been begun (e. g. washing) will be completed first of all. Note If the power supply is disconnected while the appliance is operating, e. g. by switching off the appliance or due to a power failure, all settings remain stored. Operation continues automatically as soon as the power supply is restored. Time reduction/ time saving * Pressing the "Time reduction/time saving" button provides a short wash cycle by curtailing the drying phase and the washing time. The washing and drying performance will be reduced with the Time reduction/time saving programme option. Half load* If you have only a few items to wash (e. g. glasses, cups, plates), you can switch to "Half load". The "half load" additional function saves water, energy and time. It is recommended to put a little less detergent in the detergent dispenser than for a full load. Extra dry* If you press the "Extra dry" button, you will receive a higher temperature in all programmes in the final rinse and therefore an improved drying result. (please note that higher temperatures might have an effect on delicate items). 18 en Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. Therefore you should occasionally have a careful look inside your dishwasher. Filters Waste which is deposited on the filters 28 may result in a blockage. After each washing cycle check the filters for residue. Unscrew the filter cylinder and remove the filters. The filters are permanently attached to each other and cannot be dismantled. [. . . ] When the appliance is being disposed of, the plastic waste can be sorted for environmentally-friendly recycling. Please ask your dealer or inquire at your local authority about current means of disposal. Keep children away from shipping carton and packaging components. Danger of suffocation from folding cartons and plastic film. Disposal of redundant appliances Make redundant appliances unusable to prevent subsequent accidents. [. . . ]