User manual CONSTRUCTA WFP801C7

[. . . ] Do not connect to a mixer tap of a pressureless hot water heater. - If in doubt, have the appliance connected by a technician. Water supply 1. Take the hoses out of the holders. min. 60 cm Scope of delivery Model: Aqua Stop according to model Aqua Secure Humidity in the drum is caused by the final inspection. Standard 90 cm 135 cm 3 2. [. . . ] - Soft floors/floor coverings are not suitable. Drainage into a washbasin: The washbasin outlet must not be sealed by the plug: Secure the drainage hose from slipping out. Check that the water is pumped out quickly enough. If installing the appliance on a base - Secure the washing machine feet with retention plates * (* order no. WMZ 2200, WX 975600) Drainage into a siphon: Secure connection point with hose clip, 24-40 mm (dealer). If installing the appliance on a wooden joist ceiling - If possible, install the washing machine in a corner. - Screw a water resistant wooden panel (min. - Secure the washing machine feet with retention plates * (*order no. see above). 1 2 3 4 Alignment Loud noise formation, intense vibrations and wandering" may be due to incorrect alignment! Transportation, e. g. if moving house After transporting and correctly installing and connecting the appliance, run the Empty auxiliary programme before starting the first washing programme. Align washing machine with spirit level. 1. Loosen lock nut in a clockwise direction with a wrench. 1. Before transporting the washing machine: 2. Change height by rotating the appliance feet. All four appliance feet must be firmly on the floor. Check alignment of the washing machine with a spirit level and, if required, correct. 1. See operating instructions, page 9; Detergent solution pump. Release the water pressure in the supply hose. See operating instructions, page 9; Filter in the water supply. Isolate the washing machine from the power supply. Remove the hoses. Customer service F Before calling customer service, please check whether you can eliminate the fault yourself. See Operating instructions, page 10 «What to do if . . . ». F If you require advice, even during the warranty period, you will incur costs for the call out of a technician. can find your nearest service in Please give customer service F Youproduct number (E Nr. )customerproductionthe enclosed list. the appliance. the and the number (FD) of E Nr. + Washing machine en FD 3 1 4 Product number Production number You can find the rating plate which contains this information in the frame of the open washing machine door and in the thick bordered box on the appliance rating plate at the back of the appliance. 2. 3. Tighten the lock nut against the housing. - Grip the foot and do not adjust the height. [. . . ] 10A - LS L switch) Water pressure 100-1000 kPa (1-10 bar) Waste water pipe Height from floor: min. 100 cm Test programmes according to EN 60 456 1999 and IEC 60456 Ed. 3 1998: 02 4. Appliances which feature Aqua Stop can be left unattended during operation and it is not necessary to turn off the tap afterwards. The tap should only be turned off if you are away for a prolonged period, e. g. [. . . ]