User manual CONTINENTAL EDISON CI3Z5060WP

[. . . ] Se trata de unos paneles de colores claros con acabado mate a los lados y/o el panel con acabado mate en la parte trasera del horno. Quite primero la lente del cristal y a continuación quite la bombilla. São painéis com acabamento mate e cor leve nas laterais e/ou painel de acabamento mate na traseira do forno. This User Manual contains important safety information and instructions on the operation and maintenance of your appliance. [. . . ] The hob will remain in a locked condition until it is unlocked, even if the appliance has been switched off and on. To deactivate the child lock, first switch on the hob. Simultaneously press the increase heat setting button and decrease heat setting button and then press the decrease heat setting button again. "L" will no longer be displayed and the hob will switch off. Key Lock The key lock function is used to set `safe mode' on the appliance during operation. It will not be possible to make any adjustments by pressing the buttons (for example heat settings). It will only be possible to switch the appliance off. The lock function is active if the key lock button is pressed for at least 2 seconds. this operation is acknowledged by a buzzer. After successful operation, the key lock indicator will flash and the heater will be locked. Buzzer While the hob is in operation, the following activities will be signalled by the buzzer. Continuous button operation over a longer period of time (10 seconds) will be accompanied with a longer, intermittent sound signal. Boost Function To use this function, select a cooking zone and set the desired cooking level, then press the "P" (Boost) button. The Boost function can only be activated if it is applicable with the cooking zone selected. If the Boost Function is active, a "P" will be shown on the corresponding display. Activating the booster can exceed the maximum power, in which case the integrated power management will be activated. The necessary power reduction is shown by the corresponding cooking zone display blinking. Blinking will be active for 3 seconds to allow for further adaptations of the settings before power reduction. If there is an error, an error code will be shown on the heater displays. E3 Supply voltage is other than the rated values. Switch the hob off by pressing , wait until "H" disappears for all zones, switch the hob on by pressing and continue to use. If the same error is displayed again, call an authorised service agent. [. . . ] One of the cooking zones has been on for too long. This is normal with induction hob cookware. This is caused by the transfer of energy from the hob to Solution Check the household fuse for the appliance. Check whether there is a power cut by trying other electronic appliances. [. . . ]