User manual CORBERO LF 650

[. . . ] Lavadoras automáticas Máquinas de lavar roupa Washing machines Instrucciones Instruções Instructions Lea y conserve este manual de instrucciones Leia e conserve este livro de instruções Read and keep this instructions book 35. 292. 546/0 CONTENTS Technical specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Unpacking and installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Transit security bars. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If not, run off a reasonable amount of water to flush out any debris that may have collected in the pipes. Have the permanent drainage system in the wall checked by a plumber. Place the enclosed rubber joint, delivered in a plastic bag together with the appliance (A) Fig. 6), at the very end of the inlet hose and carefully screw the pipe to the tap taking care not to damage the screwdrive and fix the nut well on to the end in order to avoid leaking. If necessary turn the hose adequately by unscrewing the nut at the rear of the appliance. 2. Lean the appliance back on the rear and fit one of the polystyrene angles between the appliance and the floor. Make sure the hoses are not squashed. 3. Carefully remove the plastic bags on the right and the left, pulling them to the centre of the appliance. Now tighten the nut anew to avoid leaks. Accurate levelling will prevent vibration, noise and displacement of the appliance during operation. Some vibration is inevitable, especially if placed on a wooden floor. Wooden floors are particularly susceptible to vibrations. If posible always place the appliance on a solid floor. 60 cm. Maximum 27 DESCRIPTION OF THE CONTROLS Control panel 1. WASHING POWDER DISPENSER The dispenser is provided with 4 compartments marked with the following symbols: BUTTON (Mod. : LF 400) Pressing this button when starting A or B programmes, the temperature will be increased from 60°C to 90°C. "1/2 LOAD" BUTTON (Mod. : LF 450, LF 550 and LF 850) Pressing this button before starting the "intense" programmes there will be one rinse less which leads to energy and water saving. "800/500"BUTTON (Mod. : LF 850) If your washing machine is provided with this push button, press it to reduce the spinning speed from 800 to 550 r. p. m. "NO SPINNING" BUTTON (Mod. : LF 450) Pressing this button before starting the "intense" washing program all spinnings will be excluded. The other steps of the program remain unchanged. "RINSE HOLD" BUTTON (delicate fabrics only) (Mod. : LF 550 and LF 850) Pressing this button together with the programs for delicate fabrics, the water will hold up in the wash tub at the end of the cycle. Press again to drain the water and take out the clothes. «Prewash» symbol shows the compartment for the prewash detergent. «Wash» symbol shows the compartment for the washing detergent. «smooth» symbol shows the compartment for the smoothing additives. «bleach» symbol shows the compartment for the bleaching additives. 2. ON/OFF LAMP It lights when the appliance is operating. 3. [. . . ] * Turn off the water tap and unscrew the inlet hose. * Select a wash program and run for a few seconds. * Position the end of the drain hose in a bowl on the floor. * Run the draining program for a few seconds. [. . . ]