User manual CORONA CONCEPTS WILLOW

[. . . ] Corona Concepts presents The Willow All Wood Dollhouse Instructions and Assembly Guide Introduction In Short . . Welcome to the exciting world of dollhouses and miniatures. Since the first tab and slot die-cut dollhouse kits arrived on the scene in the mid 1970's, their design and styling concepts have evolved swiftly. However, complexity of construction has always accompanied the great design and styling. [. . . ] Position flutes on chimney top and glue in place. Set entire chimney assembly aside, do not glue onto house yet. D) ASSEMBLY OF FIRST FLOOR FIREPLACE/BOOKCASE WALL UNIT AND LEFT SIDE CHIMNEY 1. R&P wall unit front (3), four bookcase sides (3), two wall unit sides (3), ten bookcase shelves (3), two bookcase trims (3), two bookcase door trims (3), four bookcase doors (3), (these can either be punched out and hinged, or left in place), fireplace mantel top (3), fireplace mantel bottom (3), two mantel supports(8)two fireplace hearth floor pieces(3), four fireplace hearth sides(9), and the fireplace hearth top. Glue wall unit sides on to front keeping it flush to edge of front. Using two bookcase sides and tow bookcase shelves, create a "box". Keep the shelves flush with top and bottom edges of sides -glue. Position three shelves however you choose inside this "box" and glue in place. Position this entire assembly over the bookcase opening on wall unit. Top and bottom edges should be flush - glue, Repeat for second bookcase. Turn wall unit over, glue bookcase trims in place and then glue on bookcase doors and door trims. Glue fireplace mantel top to fireplace mantel bottom. Position over fireplace opening using tab and slot, glue in place. Position and glue mantel supports under mantel on each end. Glue the two hearth floor pieces together on top of the other. With the hearth floor laying face up, glue the four hearth sides on TOP of the floor, keeping outside edges flush, then glue the hearth top over the sides, again keeping outside edges flush. Be sure to dry fit these pieces before gluing to be sure you have them positioned properly. Once properly positioned, glue together. This assembly now needs to be glued to fireplace opening in the wall unit front 5. Dry fit this entire wall unit assembly into house. Once proper fit is achieved, glue in place. R&P left side chimney front (4), six chimney sides (4), chimney front inside (5), chimney back (5), The Willow 5 chimney back inside (5), chimney top (4), four chimney top sides (4), two chimney trims (5), four chimney flute fronts (10), and four chimney flute sides (10). [. . . ] Glue gingerbread trims centered in area under window near bottom of door. R&P three pieces of front door trim (2, 5). Position and glue these three pieces on edges surrounding front door opening. Position and glue on trim over top of casing with same shape. [. . . ]