User manual COWON IAUDIO 7

[. . . ] 1. 2 (EN) 2 iAUDIO 7 Before Using Your iAUDIO 7 · COWON is a registered trademark of COWON SYSTEMS, INC. · This product is intended for personal use only and may not be used for any commercial purpose without the written consent of COWN SYSTEMS, INC. · Information in this document is copyrighted by COWON SYSTEMS, INC. and no part of this manual may be reproduced or distributed without the written permission of COWN SYSTEMS, INC. [. . . ] - Up to 24 frequencies can be stored in preset channels. Recording FM Radio 1. After the player is turned on, select the FM Radio mode. Set the tuning frequency to the desired radio station. Touch "REC" button to start recording. Touch "REC" button again to stop recording. Scheduled Recording of FM Radio Settings JetEffect Play Mode Display Timer General Recording FM Radio Timer Time setup Wakeup mode Wakeup time Sleep Auto off Wakeup time 07 : 56 PM Off 1M 8 : 0 AM Cycle : Once Duration : Always iAUDIO 7 Using Advanced Features 1. In the Settings - Timer menu, select the Wakeup Mode and set it to FM Recording. In the Settings - Timer menu, select the Wakeup Time and set it to desired time for recording. The player will turn on automatically at the specified time and starts recording the FM Radio signal. - Recorded files are stored in "RECORD" folder - During recording, battery consumption is higher than other playback operation. - Sound quality and capacity of recordings may vary according to reception quality and recording settings. See the section 4. 7 for further information 31 3. 3 Recording Using Built-In Microphone or Line-In Connection Recording with Built-in Microphone Settings JetEffect Play Mode Display Timer General Recording FM Radio Recording Linein bps Voice bps FM bps Mic volume Line volume Auto Sync Recordimg Mode 128K 64K 128K High 4 Off Voice 1. Make sure that the recording mode is set to Voice in Settings ­ Recording- Recording Mode menu. Switch to the Record mode by pressing "MENU" button and then choose Record icon. Touch "REC" button to start recording with the built-in microphone. During recording, touch the "PLAY" button to pause or resume the recording. Touch "REC" button to end recording. To play recorded files, touch "PLAY" button. iAUDIO 7 32 Using Advanced Features Recording with Line-In Connection JetEffect Play Mode Display Timer General Recording FM Radio Linein bps Voice bps FM bps Mic volume Line volume Auto Sync Recordimg Mode 128K 64K 128K High 4 LineOff In CDP Playback 1. Use the Line-In cable to connect the headphone jack of your audio source device with the Line-In jack of iAUDIO. Make sure the recording mode is set to Line-In in Settings ­ Recording ­ Recording Mode menu. Switch to the Record mode by pressing "MENU" button and then choose Record icon. Start the playback on your CDP and then press the "REC" button on iAUDIO to start recording. During recording, touch the "PLAY" button to pause or resume the recording. [. . . ] FM radio reception may be poor at locations where FM radio transmissions are shielded. If FM radio does not work where reception should be possible, please contact our service center (Note that reception quality of iAUDIO may differ from other FM radio receivers. ) There is too much noise in my recordings. iAUDIO 7 uses hard disk drive, which may interfere with the recording, thus adding noise to recorded audio. Characters on the display are corrupted. [. . . ]