User manual CRAFTSMAN 536.772210

[. . . ] Caution: Read and follow all Safety Rules and Operating Instructions before first use of this product. For two years from the date of purchase, when this Craftsman Edger is maintained, lubricated, and tuned up according to the operating and maintenance instructions in the owner's manual, Craftsman will repair, free of charge, any defect in material or workmanship. If this Craftsman Edger is used for commercial or rental purposes, this warranty applies for only 90 days from the date of purchase. This warranty does not cover the following: Expendable items which become worn during normal use, such as spark plugs, etc. [. . . ] (BEVELING OPERATION) Stop engine and disconnect the spark plug wire from the spark plug. This Edger was shipped with a 20 ounce container of SAE30 motor oil. This oil must be added to the engine before operating. Remove the oil fill cap/dipstick and fill the crankcase to FULL line on dipstick. Your engine may not require the entire 20 ounces of oil. NOTE: Engine may already contain some residual oil. Tighten the fill capldipstick securely each time you check the oil level. Pull the index lever out of the edging notch as shown above and position it in the notch marked bevel cut. reconnect the spark plug wire and start the engine. Move the depth control lever to the desired beveling z:*UTION: Never leave the Edger unattended while the engine is running. Only use high quality detergent oil rated with API service classification SG. Select the oil's SAE viscosity grade according to your expected operating temperature: ) improve starting in cold weather, these multi-viscosityoils will result in increased oil consumption when used above 32°F. Check your engine oil level more frequently to avoid possible engine damage from running low on oil. Remove the oil fill capldipstick as shown in next figure. Fill the engine crankcase, pouring slowly. CAUTION: Never fill the gas tank while the engine is running or hot. Immediately wipe off any spilled gasoline before attempting to start the engine. Include any user adjustable features therefore no other adjustments are needed. Fill the fuel tank with clean, fresh, unleaded premium, or reformulated automotive gasoline only. Be sure that the container you pour the gasoline from is clean and free from dust or other foreign particles. Never use gasoline that may be stale from long periods of storage in the container. WARNING: Experience indicates that alcohol blended fuels (called gasohol or using methanol) can attract moisture which leads to separation and formation of acids Acidic gas can damage the fuel system of an engine while in storage. [. . . ] If gasoline remains in the tank, fumes may reach an open flame, spark or pilot light from a furnace, water heater, clothes dryer, cigarette, etc. eDGER Clean the Edger thoroughly: remove all debris and wipe the unit dry. Inspect the Edger for worn or damaged parts and tighten all loose hardware. Oil all points described in the Lubrication paragraph in the MAINTENANCE section of this manual. [. . . ]