User manual CREATIVE DESKTOP WIRELESS 6000

[. . . ] User's Guide Creative Desktop Wireless 6000 Information in this document is subject to change without notice and does not represent a commitment on the part of Creative Technology Ltd. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording, for any purpose without the written permission of Creative Technology Ltd. The software described in this document is furnished under a license agreement and may be used or copied only in accordance with the terms of the license agreement. It is against the law to copy the software on any other medium except as specifically allowed in the license agreement. [. . . ] Press the Connect button on the keyboard. The Communication LED indicator on the RF receiver blinks green for about 5 sec. 1 2 3 Figure 2-6: Activating the Creative keyboard and mouse Step 5: Test the keyboard and mouse To install drivers, refer to "Installing Software" on page 3-1. Move the mouse cursor or press a key on the keyboard to test that the keyboard and mouse are connected. If nothing happens, repeat Step 4. Installing Hardware 2-4 3 Installing Software Installing Software Installing Software Windows 98 and 98 SE users may be prompted by an Add New Hardware Wizard dialog box when Windows detects a USB device. You may need to insert the Windows Installation CD into the CD-ROM drive during installation. Some computers may be supplied without the Windows CD, but have the necessary files stored in c:\windows\ options\cabs (replace c:\ with the drive letter your Windows has been installed on). You need to install software to use Creative Desktop Wireless 6000. The following instructions are applicable to Windows 98, Windows 98 Second Edition (SE), Windows Millennium Edition (Me), Windows 2000 and Windows XP. After you have connected Creative Desktop Wireless 6000, Windows will detect the USB device and install the required drivers automatically. Insert the Creative Desktop Wireless 6000 Installation CD into the CD-ROM drive. The CD supports Windows Autoplay mode and starts running automatically. If the CD does not run automatically, click Start -> Run. In the Run dialog box, type d:\ctrun\start. exe (replace d:\ with your CD-ROM drive letter) Select the applications to install, and then click the OK button. Follow the instructions on the screen to install your Creative Desktop Wireless 6000. When prompted, restart your computer. 3. Click the Apply button, and then click the OK button. To adjust the motion of the pointer, click the Motion or Pointer Options tab. Drag the top slider to adjust the pointer speed. If you want to show the pointer trail, click the Show pointer trails check box to select it, and drag the bottom slider to adjust the length of the trail. Click the Apply button, and then click the OK button. With the mouse, you can control either the scroll speed or the volume, but not both at the same time. 4. 9. Using Creative Keyboard Software 1. 2. Double-click the keyboard icon on the Windows taskbar. A user interface showing the shortcut keys on Creative Wireless Keyboard appears. [. . . ] In the Properties dialog box, click the Settings tab and select Auto Insert Notification. Click the OK button to exit from the dialog box. Troubleshooting B-1 Problems With Your Creative Wireless Keyboard or Optical Mouse The cursor does not move or its movements are erratic on the screen. Do one or more of the following: · Make sure that the batteries have been inserted properly and according to the directions shown in the battery compartment. · Make sure that the batteries are not discharged. [. . . ]