User manual CREATIVE WIRELESS RECEIVER

[. . . ] Together, your receiver and transmitter enable you to enjoy the X-Fi difference, wherever you are in your home, wirelessly. Read on to learn how to get started with your new Creative Wireless Receiver!NOTE The term "receiver" used throughout this User's Guide refers to Your remote control has an operating distance of up to three meters (approximately 9. * For use with transmitters that support iPod players. [. . . ] Your transmitter will save this combination (zones 1 and 3). receivers 1 and 3 will then be on Standby mode. NOTE Your transmitter can only save and reactivate one combination of For Sound Blaster X-Fi Notebook 1 Ensure that only receivers 1 and 3 are activated (turned on). zone buttons 1 and 3 should be highlighted in Entertainment Mode. If you have four manually paired receivers that are all activated, deactivate receivers 2 and 4 by clicking the Zone 2 and 4 buttons. It is unlikely you will experience any problem if the receiver is used in normal circumstances. Here are some tips if you do encounter these problems. try the following: · Make sure your transmitter and receiver are connected to the power outlets and turned on. ⷠMake sure the Link/Connect LEDs are green, and your units are paired. See also "Why can't I hear any sound from my speakers?This indicates that the signal from the transmitter is weak or the receiver has lost its connection with the transmitter. try the following: · Move your transmitter and receiver closer to each other. ⷠReposition your transmitter or receiver so that there are fewer objects (for example, multiple walls or large metal structures) between them. ⷠMake sure your transmitter and receiver are not placed on metal surfaces. Disconnect the transmitter and receiver from the power source. Then reconnect them again and reset the wireless connection. ⷠSet your receiver's Mode switch according to the transmitter you are using. I cannot hear music playing from my receiver. try the following: · First turn on other wireless products in the vicinity. For example, turn on your wireless router first, before turning on your transmitter. ⷠFor Xdock Wireless and Xmod Wireless only: Disconnect the transmitter from the power source, and then reconnect it back in. Your transmitter will take a few seconds to perform its built in "sniffer" function to detect and automatically select the best wireless channel to use before resuming normal operation. [. . . ] Good speaker placement can enhance your listening experience, while careless placement can make good audio systems sound bad. Below is our recommendation for stereo speakers. How do I change the wireless zone number of my receivers? do the following: Return the transmitter to factory default settings. [. . . ]