User manual CRESTON MOBILE QUICK START GUIDE

[. . . ] Locate the sample VT Pro-e project for the iPhone/iPod touch at www. crestron. com/exampleprograms, and then download it to your computer. If desired, modify the project or create a new project, and then compile the project. NOTE: In VT Pro-e, names of the panel types are Crestron Mobile and Crestron Mobile Pro. NOTE: When used with the free Crestron Mobile app, the VT Pro-e project is limited to about 10 pages; however, the limitation also depends on the complexity of the project (for example, number of buttons, graphics, and so on). [. . . ] For information about setting up a host name, refer to Answer ID 4863 in the Online Help section of the Crestron website (http://support. crestron. com). Using Crestron Toolbox, configure the Ethernet addressing parameters of the control system: a. From the Functions menu of the System Info tool, select Ethernet Addressing. The "Ethernet Addressing" window opens. "Ethernet Addressing" Window Crestron Mobile and Crestron Mobile Pro NOTE: The router configuration screen shown above is a sample screen only. The screen that appears for the particular router you are configuring may differ from the sample screen shown. Since most ISPs block port 80, open up the HTTP port to the control system using a TCP port number other than 80. Use a number such as 8081 as used for the Webport (HTTP port) in the sample router configuration screen. Note that the port number you use maps to HTTP port number 80 on the control system in step 1c. Configure the iPhone/iPod touch: NOTE: The form at www. crestron. com/crestronmobilesetup should be completed by an authorized Crestron installer if the customer is to configure the iPhone/iPod touch. The instructions in this guide will then be e-mailed to the customer to provide assistance with the installation and startup of the Crestron app from the iPhone/iPod touch. On the home screen, tap the Crestron app icon ( for Crestron Mobile or for Crestron Mobile Pro). When configuring the iPhone/iPod touch for the first time, the screen appears empty. The system configuration screen opens. Setup Screen (Empty) g. Observe that the Port A: and Port B: fields are automatically populated with the default values of 41790 and 41791, respectively. If the first TCP/IP server port number in the SIMPL Windows program was changed from the default value of 41790 to another value, tap the Port A: field and replace 41790 with the assigned value. The next consecutive TCP/IP port number is automatically entered into the Port B: field. NOTE: If the firmware version of the control system is 4. 003. xxxx or later, the port numbers used for Port A and Port B must be the same; therefore, enter into the Port B: field the same value assigned in the Port A: field. Tap the Passcode: field, and then enter the passcode assigned in the SIMPL Windows program. The setup screen opens, listing the control system that has been added. Select the name/location of the control system, and then tap Connect. The Loading Configuration message appears in addition to a progress indicator. Sample System Setup b. Enter a static IP address and related network information. [. . . ] The Check for Update function allows startup of the application to check for an update of the VT Pro-e project that is loaded in the control system. If an updated project is found, the project is automatically loaded to the iPhone/iPod touch. If Check for Update is disabled (set to OFF), the Crestron app uses the last project that was loaded to the iPhone/ iPod touch. NOTE: While developing and testing your projects, be sure to have the Check for Update function enabled (set to ON) so that you will see your project changes after you upload a new project. Crestron, Crestron Mobile, Crestron Mobile Pro, and VT Pro-e are registered trademarks of Crestron Electronics, Inc. SystemBuilder and SIMPL are trademarks of Crestron Electronics, Inc. [. . . ]