User manual CRESTRON C2N-DAP8

[. . . ] Crestron C2N-DAP8 Digital Audio Processor Operations Guide This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON Manufactured under license from Dolby Laboratories. "Dolby", "Pro Logic", "Pro Logic II", "Dolby Digital", "Dolby Digital 5. 1", and the double-D symbol are trademarks of Dolby laboratories. Manufactured under license from Digital Theater Systems, Inc. [. . . ] The UTILITY pane lets you select the AUDIO switching utilities, or SYSTEM SETUP. (The VIDEO switching utility does not apply for the C2N-DAP8. ) The TONE CONTROL pane provides controls appropriate to the chosen audio source and decoding mode. For example, the DYNAMIC RANGE selections MIN, STD, and MAX, shown in the illustration, apply the indicated amount of compression for Dolby Digital sources, as follows: MIN provides the highest compression ratio, bringing dynamic range close to that of a TV broadcast. STD provides the dynamic range recommended by sound engineers for general home viewing. MAX provides the full dynamic range of a cinema. System Setup To begin, select SYSTEM SETUP. The display provides a set of buttons you use to select the parts of the system to be configured--SPEAKER CONFIG, AUDIO CONFIG, and EQ'S--plus AUDIO SWITCH which is used to set the internal routing of audio signals. (The VIDEO SWITCH selection does not function for the C2N-DAP8. ) Initially, the large screen area to the right is blank. Select the first button, SPEAKER CONFIG. The screen displays the SPEAKER CONFIG window. 34 · Digital Audio Processor: C2N-DAP8 Operations Guide - DOC. 8186 Crestron C2N-DAP8 SPEAKER CONFIG Window Digital Audio Processor Use this screen to specify the speaker arrangement of your system and to set the crossover frequency for the subwoofer. Click on the appropriate buttons to identify the existing speaker arrangement. Note that the front and the surround speakers are treated as pairs. Select the appropriate one of the X-OVER buttons to specify the crossover frequency for the subwoofer (if present). The distinction between large and small speakers here is their ability to provide effective sound in the low frequency range (120 Hz and below), not their physical size. Speakers designated as large will receive low frequency signals. Low frequency signals appearing in channels with speakers designated as small will be filtered out and routed to the subwoofer. Check the frequency range rating of all speakers to determine their proper setting. Audio Configuration Select the AUDIO CONFIG button. The screen displays the AUDIO CONFIG window. Use this screen to set up the volume trims, the delays, and the noise generator settings. These settings are used together during room calibration. Operations Guide ­ DOC. 8186 Digital Audio Processor: C2N-DAP8 · 35 Digital Audio Processor AUDIO CONFIG Window Crestron C2N-DAP8 Use the VOLUME TRIMS settings to specify the relative gain for each speaker in the room. Settings range from ­12dB to 12dB in 0. 5dB increments. [. . . ] Return freight charges following repair of items under warranty shall be paid by CRESTRON, shipping by standard ground carrier. In the event repairs are found to be non-warranty, return freight costs shall be paid by the purchaser. 2. 3. CRESTRON Limited Warranty CRESTRON ELECTRONICS, Inc. warrants its products to be free from manufacturing defects in materials and workmanship under normal use for a period of three (3) years from the date of purchase from CRESTRON, with the following exceptions: disk drives and any other moving or rotating mechanical parts, pan/tilt heads and power supplies are covered for a period of one (1) year; touchscreen display and overlay components are covered for 90 days; batteries and incandescent lamps are not covered. This warranty extends to products purchased directly from CRESTRON or an authorized CRESTRON dealer. [. . . ]