User manual CRESTRON LEPB-2 LEPB-3

[. . . ] · Architectual Systems ­ Works with all families. NOTE: For dimmers that include a Neutral wire, the dimmer Neutral wire must be connected. NOTE: The PE200 has a minimum level adjustment. Power Extender Power Extender Wallplate TOP Raised Cover Mounting Screws (4 Places) TOP Power Extender Power Extender Wallplate Figure 2: End View Figure 3: Front View Figure 4: Front View Spacing TOP FCC COMPLIANCE STATEMENT This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. [. . . ] The remedies provided herein are the exclusive remedies under this warranty, whether based on contract, tort or otherwise. For Technical Assistance Call: 1-800-824-3005 (U. S. A. Only) 1 800 405-5320 (Canada Only) www. leviton. com DI-000-PE200-00A-Pilot OTHER CAUTIONS: 1. BOTH LIGHTING FIXTURE AND CONTROLLER MUST BE GROUNDED. DISCONNECT POWER WHEN SERVICING FIXTURE OR CHANGING LAMPS. TO BE USED FOR DIMMING ONLY WITH ADVANCE MARK XTM DIMMING BALLASTS. USE THIS DEVICE ONLY WITH COPPER OR COPPER CLAD WIRE. WITH ALUMINUM WIRE USE ONLY DEVICES MARKED CO/ALR OR CU/AL. NOTE: The Power Extender must be installed in a 1900 Box with Raised Cover or a properly grounded metal 2gang wall box, 3. 5" (8. 9 cm) deep (refer to Figure 1A and 1B). Depending on the application and the number of connections, more space may be needed. If so, use an appropriate size box or box extension. WARNING: TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER AT CIRCUIT BREAKERS OR FUSES AND TEST THAT POWER IS OFF BEFORE WIRING!MORE THAN ONE CIRCUIT BREAKER CAN POWER THIS DEVICE. DISCONNECT "ALL" POWER SOURCES BEFORE SERVICING CONTROL. Remove 1/2" (1. 3 cm) of insulation from each circuit conductor in wall box. Make sure that ends of conductors are straight. Connect lead wires per appropriate WIRING DIAGRAM and FIGURE 2 as follows: All connections to the output terminals should be made using #12 AWG wire. Each power terminal can accept up to two(2) #12 wires. The recommended installation torque is 9. 0 in. -lbs. Carefully position all wires to provide room in wall box for Power Extender. All Power Extenders must have 4-1/2" spacing above and below each unit for proper ventilation and heat dissipation (refer to Figure 4). Line voltage wiring should be at least 6 ft. away from sound or electronic equipment wiring. [. . . ] · The load does not turn ON, but the Power Extender is powered - The dimmer is OFF. - The dimmer air gap switch is activated. - The dimmer is connected to a separate circuit, and the circuit breaker is OFF. - Dimmer is mis-wired · Control Neutral (from dimmer) wire is not connected to the Neutral of the Line pair feeding the dimmer. [. . . ]