User manual CRESTRON MMK-15L WMKM-15L

[. . . ] Post-construction refers to framed walls with drywall hung. This accessory is designed with a mounting plate so that it can be placed anywhere on a wall without the support from a stud. NOTE: If necessary, consult the latest revision of the TPS-12L/15L/17L Operations Guide (Doc. 6355), the TPS-12G/15G-L Operations Guide (Doc. [. . . ] Run the necessary cables for the touchpanel and secure them behind the drywall. When dry, the touchpanel can be installed using the four tapped holes in the PMK-15L. Refer to the latest revision of the TPS-12L/15L/17L Operations Guide (Doc. 6355), the TPS-12G/15G-L Operations Guide (Doc. 6356), or the TPMC-15/17-L Series Operations Guide (Doc. 6354) for installation instructions. WMKM-15L Procedure The procedure in this section provides the necessary steps for the assembly and installation of the WMKM-15L into a wall. Complete the steps in the order provided. The only tools or materials required and not supplied are a drywall saw or equivalent, a level, four standard drywall screws, #2 Phillips screwdriver, and tools/material to apply drywall joint compound. CAUTION: Allow an air gap of at least 12 inches in the wall cavity above the touchpanel for heat dissipation. Insert the two pins on one fastener plate into the top two outer holes on the mounting plate, as shown in the following illustration. Create the Fastener/Mounting Plate Assembly (1) MOUNTING PLATE (2012920) (4)PUSH-ON FASTENER (2004121) (2) FASTENER PLATE (2004825) 2. Slide a push-on fastener over each pin on the fastener plate to loosely secure the fastener plate and the mounting plate. Do not push the pushon fasteners all the way down onto the pins. Slide them on enough to keep the fastener plate and mounting plate as one fastener/mounting plate assembly. Use the second fastener plate and repeat steps 1 and 2 using the lower two PMK-15L pins. Locate an area on the wall that is free of miscellaneous wiring and studs. Make a small hole near the middle of the designated site; verify that the location is suitable. 3. 5. NOTE: Make the cutout as level as possible. The mounting plate allows for only minor leveling adjustments. Installation Guide ­ DOC. 6364 Mud Mount Kits: MMK-15L & WMKM-15L · 5 Mud Mount Kits 6. 7. Crestron MMK-15L & WMKM-15L Use the drywall saw or equivalent to produce a level, rectangular cutout in the drywall as shown on page 2. Insert the symmetrical mud ring plate into the opening, as shown in the illustration after this step. Insert the Mud Ring Plate into the Opening IMPORTANT PLEASE MAKE DRYWALL CUTOUT AS LEVEL AND CLEAN AS POSSIBLE. THE MOUNTING PLATE ALLOWS FOR ONLY MINOR ADJUSTMENT OF THE TOUCHPANEL. FLANGE HOLES FOR DRYWALL SCREWS (PROVIDED BY OTHER) SCREW LENGTH SHOULD NOT EXCEED DRYWALL THICKNESS BY MORE THAN 1/2". MUD RING PLATE (2013005) 8. Carefully pass the fastener/mounting plate assembly through the opening and rest the assembly against the interior surface of the drywall. Verify that the fastener plates are between the mounting plate and the drywall. [. . . ] Except as expressly set forth in this warranty, CRESTRON makes no other warranties, expressed or implied, nor authorizes any other party to offer any warranty, including any implied warranties of merchantability or fitness for a particular purpose. Any implied warranties that may be imposed by law are limited to the terms of this limited warranty. This warranty statement supercedes all previous warranties. Trademark Information All brand names, product names, and trademarks are the sole property of their respective owners. Windows is a registered trademark of Microsoft Corporation. [. . . ]