User manual CRESTRON MMK-3000L WMKM-3000L

[. . . ] NOTE: If necessary, consult the latest revision of the TPS-3000L Operations Guide (Doc. 6077) for a complete list of mounting options. Supplied Hardware The MMK-3000L consists of three parts. These parts produce an assembly that attaches to the PMK-3000L or BB-3000L. The WMKM-3000L consists of the same three parts that make up the MMK-3000L as well as one mounting plate. [. . . ] Avoid covering the 4 tapped mounting holes. Run the necessary cables for the touchpanel and secure them behind the drywall. When dry, the TPS-3000L can be installed using the four tapped holes in the PMK-3000L. Refer to the latest revision of the TPS-3000L Operations Guide (Doc. 6077) for details. WMKM-3000L Procedure The procedure in this section provides the necessary steps for the assembly and installation of the WMKM-3000L into a wall. Complete the steps in the order provided. The only tools or materials required and not supplied are a drywall saw or equivalent, a level, four standard drywall screws, #2 Phillips screwdriver, and tools/material to apply drywall joint compound. Insert the two pins on one fastener plate into the top two outer holes on the mounting plate, as shown in the illustration after this step. (4) PUSH-ON FASTENER Create the Fastener/Mounting Plate Assembly MOUNTING PLATE FASTENER PLATE Installation Guide ­ DOC. 6021 Mud Mount Kits: MMK-3000L & WMKM-3000L · 5 Mud Mount Kits 2. Crestron MMK-3000L & WMKM-3000L Slide a push-on fastener over each pin on the fastener plate to loosely secure the fastener plate and the mounting plate. Do not push the pushon fasteners all the way down onto the pins. Slide them on enough to keep the fastener plate and mounting plate as one fastener/mounting plate assembly. Use the second fastener plate and repeat steps 1 and 2 using the lower two PMK-3000L pins. Locate an area on the wall that is free of miscellaneous wiring and studs. Make a small hole near the middle of the designated site; verify that the location is suitable. 3. 5. NOTE: Make the cutout as level as possible. The mounting plate allows for only minor leveling adjustments. Use the drywall saw or equivalent to produce a level, rectangular cutout in the drywall as shown on page 2. Insert the symmetrical mud ring plate into the opening, as shown in the illustration after this step. Insert the Mud Ring Plate into the Opening 8. Carefully pass the fastener/mounting plate assembly through the opening and rest the assembly against the interior surface of the drywall. Verify that the fastener plates are between the mounting plate and the drywall. 6 · Mud Mount Kits: MMK-3000L & WMKM-3000L Installation Guide ­ DOC. 6021 Crestron MMK-3000L & WMKM-3000L 9. Mud Mount Kits When the fastener/mounting plate assembly is in position, bend the top two flanges of the mud ring upward (approximately 90 degrees) and the bottom two flanges downward (approximately 90 degrees). Refer to the illustration after this step. NOTE: Fastener/mounting plate assembly will have slight play; this is normal. It allows for minor adjustments to the TPS-3000L during installation. Bend Flanges 10. [. . . ] CRESTRON reserves the right in its sole and absolute discretion to charge a 15% restocking fee, plus shipping costs, on any products returned with an RMA. Return freight charges following repair of items under warranty shall be paid by CRESTRON, shipping by standard ground carrier. Any implied warranties that may be imposed by law are limited to the terms of this limited warranty. This warranty statement supercedes all previous warranties. Trademark Information All brand names, product names, and trademarks are the sole property of their respective owners. [. . . ]