User manual CRESTRON MMK-4L WMKM-4L

[. . . ] This accessory is designed with a mounting plate so that it can be placed anywhere on a wall without the support of a stud. NOTE: If necessary, consult the latest revision of the TPS-4L Operations Guide (Doc. 6449) or the TPMC-4L Operations Guide (Doc. 6450) for a complete list of mounting options. [. . . ] Apply drywall joint compound as needed to finish the cutout. Avoid covering the four tapped mounting holes. 10. Run the necessary cables for the touchpanel and secure them behind the drywall. When dry, the touchpanel can be installed using the four tapped holes in the PMK-4L. Refer to the latest revision of the TPS-4L Operations Guide (Doc. 6449) or the TPMC-4L Operations Guide (Doc. 6450) for installation instructions. Installation Guide ­ DOC. 6389 Mud Mount Kits: MMK-4L & WMKM-4L · 5 Mud Mount Kits WMKM-4L Procedure Crestron MMK-4L & WMKM-4L The procedure in this section provides the necessary steps for the assembly and installation of the WMKM-4L into a wall. Review the procedure and complete the steps in the order provided. The only tools or materials required and not supplied are a drywall saw or equivalent, a level, four standard drywall screws, #2 Phillips screwdriver, and tools/material to apply drywall joint compound. CAUTION: Allow an air gap of at least 12 inches in the wall cavity above the touchpanel for heat dissipation. Insert the two pins on one adjustment plate into the top two outer holes on the mounting plate, as shown in the following illustration. Create the Adjustment/Mounting Plate Assembly (4) PUSH-ON FASTENER (2004121) (1) MOUNTING PLATE (2013242) (2) ADJUSTMENT PLATE (2013243) 2. Slide a push-on fastener over each pin on the adjustment plate to loosely secure the adjustment plate and the mounting plate. Do not push the push-on fasteners all the way down onto the pins. Slide them on enough to keep the adjustment plate and mounting plate as one adjustment/mounting plate assembly. Use the second adjustment plate and repeat steps 1 and 2 using the lower two pins. Locate an area on the wall that is free of miscellaneous wiring and studs. Make a small hole near the middle of the designated site; verify that the location is suitable. 3. 5. NOTE: Make the cutout as level as possible. The mounting plate allows for only minor leveling adjustments. Use the drywall saw or equivalent to produce a level, rectangular cutout in the drywall as shown on page 3. Insert the symmetrical mud ring plate into the opening, as shown in the illustration after this step. 6 · Mud Mount Kits: MMK-4L & WMKM-4L Installation Guide ­ DOC. 6389 Crestron MMK-4L & WMKM-4L Insert the Mud Ring Plate into the Opening DRYWALL Mud Mount Kits FLANGE HOLES FOR DRYWALL SCREWS (NOT INCLUDED). [. . . ] Repaired or replaced equipment and parts supplied under this warranty shall be covered only by the unexpired portion of the warranty. Except as expressly set forth in this warranty, CRESTRON makes no other warranties, expressed or implied, nor authorizes any other party to offer any warranty, including any implied warranties of merchantability or fitness for a particular purpose. Any implied warranties that may be imposed by law are limited to the terms of this limited warranty. This warranty statement supercedes all previous warranties. Trademark Information All brand names, product names, and trademarks are the sole property of their respective owners. [. . . ]