User manual CRESTRON QS SW-DAT C2N-DAP8 RC

[. . . ] DAT Software For C2N-DAP8/RC Digital Audio Processors Quick Start These instructions provide a quick reference for using the Crestron® Digital Audio Tools (DAT) software to configure your C2N-DAP8 or C2N-DAP8RC Digital Audio Processors (DAP8/RC) to match the requirements of the listening/viewing area. For detailed instructions, refer to the Operations Guide for the DAP8/RC (Doc. 8186 or 8187) and the help file supplied with the DAT software. Getting Started All hardware installation and wiring procedures should be completed before attempting to configure the DAP8/RC unit. The following items are required for room calibration: · · SPL (sound pressure level) meter. [. . . ] Decoding Mode: This lists the default decoding mode for each possible input signal type. The pull-down at the right of each decoding mode lists any available alternate decoding modes that can be selected. User selection can be made for any of the available modes while operating the unit. Please refer to the help file for the specifics of each decoding mode. NOTE: Some decoding modes are not available in all speaker configurations. In such cases, the affected mode listing will be dimmed. The following is a brief description of each signal type and decoding mode available. Note that the first decoding mode listed is the default mode. Any available alternate modes are listed below the default. 2-Channel: This signal type would be a stereo source from a CD player, cable box, etc. It is the only available signal type for all analog inputs, and provides only a (front) left and right signal. Decoding Modes Available: Stereo (default) Dolby Pro Logic II Movie Dolby Pro Logic II Music Dolby Pro Logic II Matrix Dolby Pro Logic DTS Ne o6: Cinema DTS Neo6: Music User-Controlled Dolby Digital 5. 1: This is a digital input signal and provides 5. 1 channels of discrete surround sound (left, center, right, surround left, surround right, and LFE). Decoding Mode: The drop down menu lists all available decoding modes. Dolby Digital 5. 1(Default) Dolby Digital EX Dolby Pro Logic Dolby Pro Logic II Movie Dolby Pro Logic II Music Dolby Pro Logic II Matrix DTS 5. 1 DTS ES Matrix DTS ES Discrete DTS Neo6: Cinema DTS Neo6: Music Stereo Decoding Mode Volume: This slider adjusts the overall volume of the decoding mode so that it matches that of the other decoding modes. This helps to make a smooth transition from one decoding mode to another without an audible difference in volume. Speaker Adjustments: All available speakers in the project start at 0 dB and have a usable adjustment of ­30 dB to +12 dB. Adjust each speaker for the preferred level per decoding mode. LFE: This adjustment is for the Low Frequency Effects channel. The usable adjustment is ­15 dB to 0. Adjust to the preferred level per decoding mode. 6 · Digital Audio Processors: C2N-DAP8/RC Quick Start ­ DOC. 6238 Crestron DAT Software Digital Audio Tools NOTE: The level adjustments done here are in addition to the values set in the Room Calibration tab. The total gain or attenuation is represented at the bottom of each slider. [. . . ] This shows any current value for the filter and allows a new bandwidth value to be entered for the selected filter. Filter Type: This drop down menu allows the selection of one of five different filter types for adjustment of the selected filter. Refer to the help file for more information and examples of each of the filters listed. The five filters and how they affect the speaker is explained below. [. . . ]