User manual CRESTRON ST-4T8T

[. . . ] 5703 Contents · i CRESTRON Hand-Held Wireless Transmitter Description Functional Description The ST-4T and ST-8T are hand-held radio-frequency (RF) transmitters. The units are designed to operate with the SmarTouch STS via the ST-CP, control processor. The hand-held transmitter is available with four (ST-4T) or eight (ST-8T) button controls. Depression of any fixed button on the button panel initiates a RF signal transmission to the ST-CP. [. . . ] To maintain code diversity within SmarTouch STS, use codes between 10 and FE for the transmitters. NOTES: The RF ID CODE on the hand-held transmitters is factory set to 11. Do not confuse RF ID with network (NET) ID. Use STS VisionTools for Windows to set an RF ID CODE. Select ViewPort from the Tools menu; the "Crestron Performance Viewport" dialog box appears. 4 · Hand-Held Wireless Transmitter Operations Guide - DOC. 5703 CRESTRON Crestron Performance Viewport Dialog Box From the Options menu in the dialog box, select Set Transmitter ID to open the "Set Transmitter ID" dialog box. Enter a two-digit hexadecimal number ranging from 03 to FE. Click OK to confirm. Set Transmitter ID Dialog Box Programming STS VisionTools for Windows contains sample projects, ST4T. prj and ST8T. prj, that can be used when programming the hand-held wireless transmitters. Simply copy the respective sample project by selecting Copy Project from the File menu of an open project. The "Copy Project" dialog box is displayed. Operations Guide - DOC. 5703 Hand-Held Wireless Transmitter · 5 CRESTRON Copy Project Dialog Box NOTE: The illustration above shows what the "Copy Project" dialog box would look like if the programmer were to copy the ST-4T sample project with the new project name, remote-1. As illustrated, a "From" and "To" field is provided. If the desired project is not present in the field, directly key in the path name (at the From: box) or select Browse to display the "Open" dialog box and scroll through directories to establish the correct path of a desired source for the copy. The destination path is entered in the same manner. Once source and destination paths have been chosen, select Copy to initiate project copying. By default, all copied graphic files are copied to the same directory as the project or touchpanel. The sample projects for the hand-held transmitters have one page each. The ST-4T page and ST-8T page have four and eight momentary-type buttons, respectively. Each large button has two join numbers associated with it, one for each half of the button. Commands such as VOLUME UP and VOLUME DOWN are usually assigned to the separate button halves; operation of each half is achieved by pressing down on that side of the button. Refer to the following illustration of the sample ST-4T page. Notice the join number assignments for each button. 6 · Hand-Held Wireless Transmitter Operations Guide - DOC. [. . . ] RF ID or IR ID is Verify that the RF ID is properly set to match incorrectly set. NOTE: NET ID and RF ID are separate parameters. Program does not Verify correct program is loaded in system match hardware. Receiver is unplugged Verify power to the receiver. [. . . ]