User manual CRESTRON TMK-15L WMKT-15L

[. . . ] Post-construction refers to framed walls with drywall hung. This accessory is designed with a mounting plate so that it can be placed anywhere on a wall without the support from a stud. The mounting plate is also ideal for installing the touchpanel in a lectern. NOTE: If necessary, consult the latest revision of the TPS-12L/15L/17L Operations Guide (Doc. [. . . ] Complete the steps in the order provided. The only tools or materials required and not supplied are a drywall saw or equivalent and a level. Locate an area on the wall that is free of miscellaneous wiring and studs. Make a small hole near the middle of the designated site; verify that the location is suitable. NOTE: Make the cutout as level and smooth as possible. The mounting plate allows for only minor leveling adjustments. If a larger cutout is accidentally made, consider purchasing the Crestron Mud Mount Kit, MMK-15L. It and the mounting plate supplied with the WMKT-15L provide a cost-effective means of correction. Essentially, The combination of these two kits makes up the Crestron Mud Mount Kit for the Wall, WMKM-15L. Simply follow the "WMKM-15L Procedure" in the latest revision of the Mud Mount Kits Installation Guide (Doc. Use the drywall saw or equivalent to produce a level, rectangular cutout in the drywall (refer to the Drywall Cutout dimensions on page 2 for cutout dimensions). Insert the symmetrical trim ring into the opening, as shown in the following diagram. 4. 4 · Trim Ring Mount Kits: TMK-15L & WMKT-15L Installation Guide ­ DOC. 6365 Crestron TMK-15L & WMKT-15L Insert the Trim Ring into the Opening Trim Ring Mount Kits IMPORTANT PLEASE MAKE DRYWALL CUTOUT AS LEVEL AND CLEAN AS POSSIBLE. THE MOUNTING PLATE ALLOWS FOR ONLY MINOR ADJUSTMENT OF THE TOUCHPANEL. MOUNTING PLATE (2012920) TRIM RING (2013004) 5. 6. Carefully pass the mounting plate through the opening and rest it against the interior surface of the drywall. When the mounting plate is in position, bend the top two flanges of the trim ring upward (approximately 90 degrees) and the bottom two flanges downward (approximately 90 degrees). Refer to the following diagram. Bend Flanges ­ Front and Back View NOTE: The mounting plate will have slight play; this is normal. It allows for minor adjustments to the touchpanel during installation. Installation Guide ­ DOC. 6365 Trim Ring Mount Kits: TMK-15L & WMKT-15L · 5 Trim Ring Mount Kits 7. 8. Crestron TMK-15L & WMKT-15L Run the necessary cables for the touchpanel and secure them behind the drywall. The touchpanel can be installed using the four tapped holes in the mounting plate. Refer to the latest revision of the TPS-12L/15L/17L Operations Guide (Doc. 6355), the TPS-12G/15G-L Operations Guide (Doc. [. . . ] Purchasers should inquire of the dealer regarding the nature and extent of the dealer's warranty, if any. CRESTRON shall not be liable to honor the terms of this warranty if the product has been used in any application other than that for which it was intended, or if it has been subjected to misuse, accidental damage, modification, or improper installation procedures. Furthermore, this warranty does not cover any product that has had the serial number altered, defaced, or removed. This warranty shall be the sole and exclusive remedy to the original purchaser. [. . . ]