User manual CRESTRON TMK-4L WMKT-4L

[. . . ] This accessory is designed with a mounting plate so that it can be placed anywhere on a wall without the support from a stud. The mounting plate is also ideal for installing the touchpanel in a lectern. NOTE: If necessary, consult the latest revision of the TPS-4L Operations Guide (Doc. 6449) or the TPMC-4L Operations Guide (Doc. [. . . ] 6390 Crestron TMK-4L & WMKT-4L Trim Ring Mount Kits WMKT-4L Procedure The procedure in this section provides the necessary steps for installation of the WMKT-4L into a wall. Review the procedure and complete the steps in the order provided. The only tools or materials required and not supplied are a drywall saw or equivalent and a level. Locate an area on the wall that is free of miscellaneous wiring and studs. Make a small hole near the middle of the designated site; verify that the location is suitable. NOTE: Make the cutout as level and smooth as possible. The mounting plate allows only minor leveling adjustments. If a larger cutout is accidentally made, consider purchasing the Crestron Mud Mount Kit, MMK-4L. It and the mounting plate supplied with the WMKT-4L provide a cost-effective means of correction. Essentially, the combination of these two kits makes up the Crestron Mud Mount Kit for the Wall, WMKM-4L. Simply follow the "WMKM-4L Procedure" in the latest revision of the Mud Mount Kits Installation Guide (Doc. Use the drywall saw or equivalent to produce a level, rectangular cutout in the drywall, as shown on page 3. Insert the trim ring into the opening, as shown in the following diagram. Insert the Trim Ring into the Opening IMPORTANT MAKE DRYWALL CUTOUT AS LEVEL AS POSSIBLE. MOUNTING PLATE ALLOWS ONLY MINOR ADJUSTMENT OF THE TOUCHPANEL. MOUNTING PLATE (2013242) TRIM RING (2013241) 5. Carefully pass the mounting plate through the opening and hold it against the interior surface of the drywall. Installation Guide ­ DOC. 6390 Trim Ring Mount Kits: TMK-4L & WMKT-4L · 5 Trim Ring Mount Kits 6. Crestron TMK-4L & WMKT-4L When the mounting plate is in position, bend the top two flanges of the trim ring upward (approximately 90 degrees) and the bottom two flanges downward (approximately 90 degrees). Refer to the following diagram. Bend Flanges NOTE: The mounting plate will have a little play; this is normal. It allows for minor adjustments to the touchpanel during installation. Run the necessary cables for the touchpanel and secure them behind the drywall. The touchpanel can be installed using the four tapped holes in the mounting plate. Refer to the latest revision of the TPS-4L Operations Guide (Doc. 6449) or the TPMC-4L Operations Guide (Doc. 6450) for details. CAUTION: Allow an air gap of at least 12 inches in the wall cavity above and below the touchpanel for heat dissipation. 6 · Trim Ring Mount Kits: TMK-4L & WMKT-4L Installation Guide ­ DOC. [. . . ] Furthermore, this warranty does not cover any product that has had the serial number altered, defaced, or removed. This warranty shall be the sole and exclusive remedy to the original purchaser. In no event shall CRESTRON be liable for incidental or consequential damages of any kind (property or economic damages inclusive) arising from the sale or use of this equipment. CRESTRON is not liable for any claim made by a third party or made by the purchaser for a third party. [. . . ]