User manual CRESTRON TPS-6X

[. . . ] Crestron TPS-6X Isys® 5. 7" Wireless Touchpanel Operations Guide This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON All brand names, product names and trademarks are the property of their respective owners. ©2008 Crestron Electronics, Inc. Crestron TPS-6X Isys® 5. 7" Wireless Touchpanel Contents Isys® 5. 7" Wireless Touchpanel: TPS-6X 1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Features and Functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The TPS-6X does not require any connections for wireless operation but does need to be acquired by a CEN(I)-HPRFGW gateway (sold separately). Refer to "WIRELESS" which starts on page 27 and to the "Operation" section of the latest version of the CEN(I)-HPRFGW High Powered Gateway Operations Guide (Doc. For Cresnet or Ethernet connection or to upgrade touchpanel firmware, the TPS-6X must be placed on the TPS(I)-6X-DS Docking Station, which must be connected to the TPS-6X IMCW Interface Module (both included), which in turn must be connected to a control system via Cresnet or Ethernet. For details, refer to the latest version of the TPS-6X-DS Operations & Installation Guide (Doc. 6576) and the TPS-6X-IMCW Installation Guide (Doc. Make the necessary connections as called out in the illustrations on the following pages. Refer to "Network Wiring" on page 12 before attaching the 4-position terminal block connector. Apply power after all connections have been made. When making connections to the TPS-6X-IMCW, use Crestron power supplies for Crestron equipment. To mount the TPS-6X, the touchpanel must first be positioned onto the docking station at a slight angle to latch the top portion of the docking station onto the touchpanel. Magnets on the TPS(I)-6X-DS attach to metal plates installed on the TPS-6X to secure the touchpanel in place (refer to the following illustration). Operations Guide ­ DOC. 6575B Isys® 5. 7" Wireless Touchpanel: TPS-6X · 33 Isys® 5. 7" Wireless Touchpanel Touchpanel Mounting Crestron TPS-6X LATCH THIS PART OF THE DOCKING STATION ONTO THE BACK OF THE TOUCHPANEL FIRST MAGNETS Hardware Connections for the TPS-6X-IMCW (Front) TO PANEL: CONNECT TO TPS(I)-6X-DS VIA 10-PIN RJ-50 CABLE (CABLE PROVIDED WITH TPS(I)-6X-DS) POWER: FROM POWER PACK (12 VDC, 1. 5A) 34 · Isys® 5. 7" Wireless Touchpanel: TPS-6X Operations Guide ­ DOC. 6575B Crestron TPS-6X Isys® 5. 7" Wireless Touchpanel Hardware Connections for the TPS-6X-IMCW (Rear) POWER: FROM POWER PACK (12 VDC, 1. 5A) VIDEO IN: BALANCE OR UNBALANCED SOURCE NET: TO CONTROL SYSTEM OR ANY OTHER CRESNET DEVICE LAN: 10/100BASE-T TO LAN NOTE: Ensure the TPS-6X-IMCW is properly grounded. NOTE: The TPS-6X-IMCW can be powered via the 12 VDC jack on either the front or the back of the unit if the NET port is not being used to power the module. Recommended Cleaning Touchscreen Keep the surface of the touchscreen free of dirt, dust or other materials that could degrade optical properties. Long-term contact with abrasive materials can scratch the surface, which may detrimentally affect image quality. For best cleaning results, use a clean, damp, non-abrasive cloth with any commercially available non-ammonia glass cleaner. Bezels may not provide a complete watertight seal. Therefore, apply cleaning solution to the cloth rather than the surface of the touchscreen. Wipe touchscreen clean and avoid getting moisture beneath the bezels. CAUTION: Do not apply excessive pressure to the touchscreen display during handling. Doing so can crack the screen and damage the touchpanel. Enclosure The soft felt bag the TPS-6X came shipped in can be used to clean the bezel and the rest of the touchpanel enclosure. Operations Guide ­ DOC. [. . . ] Authorized returns must be shipped freight prepaid to CRESTRON, 6 Volvo Drive, Rockleigh, N. J. or its authorized subsidiaries, with RMA number clearly marked on the outside of all cartons. Shipments arriving freight collect or without an RMA number shall be subject to refusal. CRESTRON reserves the right in its sole and absolute discretion to charge a 15% restocking fee plus shipping costs on any products returned with an RMA. [. . . ]