User manual CRESTRON TPS-MEM16MB 32MB

[. . . ] This action can be taken locally (user interface within close physical proximity, and not necessarily networked) or remotely (networked user interface located over some distance). Local Verification Simply enter 'SETUP MODE' as described in the "Configure the . . . " section of each user interface Operations Guide. From the Main Menu, navigate to the Diagnostics Menu and select the Display Configuration button. The new screen displays a list of configuration information. Search for the item titled 'Flash Total Size'. [. . . ] The two metallic side clips snap into place as it becomes seated. If removed, return the TPS-VID expansion card. Position the touchpanel base cover onto the base. Hold the touchpanel base cover in place and position the touchpanel facedown onto a padded surface to prevent scratching of the screen. 6 · Flash Memory for TPS User Interfaces: TPS-MEM16MB & TPS-MEM32MB Installation Guide - DOC. 5927 Crestron TPS-MEM16MB & TPS-MEM32MB Flash Memory 18. Re-install the eight base cover screws to finger-tight then, using a Philips screwdriver, tighten an additional 1/8-turn. Re-connect all cables to the appropriate touchpanel rear panel ports. If the optional external power pack is utilized, connect the plug of the power pack to the touchpanel rear port labeled 24VDC 2A. Lectern Model Installation Procedure CAUTION: The memory module and the TPS lectern-model user interface contain ESD sensitive devices. Perform the following procedure while wearing a grounding strap that is properly grounded or on a grounded workstation to avoid damaging the module and/or the user interface. NOTE: The diagrams in this procedure show a TPS-6000L touchpanel but the steps for all other lectern-model TPS user interfaces are identical. This procedure pertains to an interface that is NOT installed into a wall or lectern. If already installed, refer to the latest revision of the user interface Operations & Installation Guide or, if applicable, the back box Installation Guide. Disconnect power and perform the installation procedure in reverse to remove the user interface. The latest version of the Operations & Installation Guide can be obtained from the Downloads page (MANUAL Library) of Crestron's website (www. crestron. com). New users are required to register in order to obtain access to the FTP site. To prevent scratching of the screen (TPS-TPI excluded), place the touchpanel facedown onto a padded surface. Installation Guide - DOC. 5927 Flash Memory for TPS User Interfaces: TPS-MEM16MB & TPS-MEM32MB · 7 Flash Memory Crestron TPS-MEM16MB & TPS-MEM32MB 2. Refer to the diagram below. Using a #1 Phillips screwdriver, loosen and remove the 10 screws that secure the touchpanel rear cover. Remove Touchpanel Rear Cover Screws CAUTION: The connectors of any optional card that is already installed may have to be aligned slightly to allow the rear cover to be removed. Align the connectors carefully to prevent damage to the card, cover, or touchpanel. 8 · Flash Memory for TPS User Interfaces: TPS-MEM16MB & TPS-MEM32MB Installation Guide - DOC. 5927 Crestron TPS-MEM16MB & TPS-MEM32MB Flash Memory 3. As shown below, remove the touchpanel rear cover by sliding it towards the bottom of the touchpanel. Remove Touchpanel Rear Cover 4. To obtain unobstructed access to the memory socket, remove the PCB blank plate or previously installed TPS-VIDL expansion card. Each procedure is defined in the following sub-steps. If the PCB blank plate is observed, refer to the diagram on the next page. [. . . ] In no event shall CRESTRON be liable for incidental or consequential damages of any kind (property or economic damages inclusive) arising from the sale or use of this equipment. CRESTRON makes no other warranties nor authorizes any other party to offer any warranty, expressed or implied, including warranties of merchantability for this product. This warranty statement supersedes all previous warranties. Trademark Information All brand names, product names, and trademarks are the sole property of their respective owners. Windows is a registered trademark of Microsoft Corporation. [. . . ]