User manual CRESTRON TPS-XBTP

[. . . ] The latest versions of the guides are available from the Downloads | Product Manuals section of the Crestron website (www. crestron. com). Operations and Installation Guide - DOC. 5845 Battery Pack for TPS-XTXRF: TPS-XBTP · 1 Battery Pack for TPS-XTXRF Crestron TPS-XBTP Physical Description The TPS-XBTP is housed in a black enclosure with its electrical contacts located on the bottom (see views below). TPS-XBTP Top, Side & Rear Views 5. 00 in (12. 70 cm) 7. 14 in (18. 14 cm) 1. 40 in (3. 56 cm) TPS-XBTP Bottom View ELECTRICAL CONTACTS 2 · Battery Pack for TPS-XTXRF: TPS-XBTP NICKEL-MH BATTERY: MUST BE RECYCLED OR DISPOSED OF PROPERLY. CAUTION DO NOT BURN OR PUNCTURE BATTERY. DOING SO COULD RELEASE TOXIC MATERIALS WHICH COULD CAUSE INJURY. DO NOT SHORT CIRCUIT. Operations and Installation Guide - DOC. [. . . ] Best results occur if the TPS-XBTP is stored within a temperature range of -4°F to 113°F (-20°C to +45°C). After an extended storage, allow the battery pack to obtain room temperature, discharge fully, and charge to restore full capacity. When storing battery pack for more than 1-year, charge at least once a year to prevent leakage and deterioration in performance due to self-discharging. 4 · Battery Pack for TPS-XTXRF: TPS-XBTP Operations and Installation Guide - DOC. 5845 Crestron TPS-XBTP Battery Pack for TPS-XTXRF Charging & Discharging NOTE: Typically, the battery pack is good for 500 charge/discharge cycles. Charging To charge the TPS-XBTP: · Use the TPS-XBC Battery Charger; or · Install the TPS-XBTP in a TPS-XTXRF equipped touchpanel that is docked to a powered TPS-XDS Docking Station. NOTE: An external power pack or Cresnet power connected directly to the TPS-XTXRF equipped touchpanel does NOT charge the TPS-XBTP. For further information, consult the TPS-XBC Operations Guide (Doc. 6017) and TPS-XDS Operations Guide and (Doc. The latest versions of the guides are available from the Downloads | Product Manuals section of the Crestron website (www. crestron. com). Discharging Over time, the battery pack may not accept a full charge. If you think that the touchpanel's level indicator is inaccurate, you may need to discharge the battery. For example, the level indicator may read 80%, even though the charge LED on the TPS-XDS goes out (indicating a full charge). If this occurs, you need to fully discharge the battery pack. To discharge, insert the battery pack in an undocked TPS-XTXRF equipped touchpanel, and allow the touchpanel to remain ON until it no longer operates and/or the control system power/battery gauge indicates minimum. This also establishes the gauge minimum level. NOTE: After fully discharging the battery, fully charge the battery (see Charging instructions above). NOTE: The battery pack discharges at a rate of 25% per month when not used, which may cause an inaccurate reading on the level indicator. Operations and Installation Guide - DOC. 5845 Battery Pack for TPS-XTXRF: TPS-XBTP · 5 Battery Pack for TPS-XTXRF Crestron TPS-XBTP Installation The TPS-XBTP is designed to prevent improper installation. The unit fits only one way in the battery compartment of a touchpanel equipped with the TPS-XTXRF. To install the TPS-XBTP, refer to the following diagram. Note the bottom-center slot of the TPS-XTXRF and insert the battery pack in the touchpanel until it snaps in place. Insert TPS-XBTP into Touchpanel 6 · Battery Pack for TPS-XTXRF: TPS-XBTP Operations and Installation Guide - DOC. 5845 Crestron TPS-XBTP Battery Pack for TPS-XTXRF Removal To remove the TPS-XBTP from a touchpanel equipped with the TPS-XTXRF, press down the battery eject button, allow the battery pack to eject approximately 1/4-inch and remove the pack. [. . . ] Shipments arriving freight collect or without an RMA number shall be subject to refusal. CRESTRON reserves the right in its sole and absolute discretion to charge a 15% restocking fee, plus shipping costs, on any products returned with an RMA. Return freight charges following repair of items under warranty shall be paid by CRESTRON, shipping by standard ground carrier. In the event repairs are found to be non-warranty, return freight costs shall be paid by the purchaser. 2. 3. CRESTRON Limited Warranty CRESTRON ELECTRONICS, Inc. [. . . ]