User manual CRIVIT SPORTS LD2940

[. . . ] Please read the note to avoid incorrect operation. WARNING CAUTION NOTE: Reference: Provides the reference information and related functions that are useful in operating. We recommend that you read these references. WARNING · Please place light meter in a location where an infant cannot reach and accidentally get the strap wrapped around his or her neck. · Keep the synchro terminal cap out of reach of young children, as swallowing such objects can cause suffocation. · Never place batteries in fire, short, disassemble, heat or charge them. [. . . ] (see page 21) of "Cord flash mode" of section 2-1. · A new converted value is displayed when the ISO sensitivity is changed after taking the measurement. · Readings outside the display range or beyond the measuring range are similar to the previous instruction. (see page 16) of "Shutter speed priority mode" of section 1-1. · You can select aperture scale or EV scale by holding Mode button and pressing AVE. · The meter's tripod socket permits mounting it to a tripod or light stand and placing it strategically when using cordless flash mode. Measurement 2-3 Cord multiple flash (cumulative) mode These measurements are used when the light generated by the flash is inadequate for proper exposure. The repeated flash pops can be accumulated until the desired aperture is displayed. Only one digit is displayed if the cumulative number is ten or more. Display returns 0 (0=10, 1=11, 2=12, etc. ) To activate Multiple cumulative mode, please set custom setting no. 6 and Item no. 1. Hold down the Mode button and turn the Jog wheel to select cord multiple flash (cumulative) . When setting shutter speed, first check the settings to confirm that they correspond to the settings available on the camera. -25- 5. When the light from the flash is received, the measured value (f stop) is displayed. Each time this is repeated, the accumulated value for the aperture and the number of cumulative flashes is displayed. Percentage of flash in total exposure Measured f stop Number of cumulative flashes 1/10 f stop Set shutter speed 1st. time Measured f stop (total exposure) 3rd. The ready to measure mode will be displayed for approximately 90 seconds. If the 90 second period is exceeded and the blinking mark stops, press the Measuring button again. The measured value (f stop) of the previous time reverts to 0 and the meter is in ready to measure mode. NOTE: · When firing a flash, if the flash brightness is 8 EV lower than the ambient light, the meter may fail to detect the light. In this case, make measurements using the flash with cord multiple flash (cumulative) mode (see page 24) or wireless multiple flash radio triggering mode (see page 29). · Rapid start fluorescent lamps and special lighting are sometimes mistaken for flash, and accidentally measured. In this case, make measurements using the flash with cord multiple flash (cumulative) mode (see page 24) or wireless multiple flash radio triggering mode (see page 29). [. . . ] This will cause it to malfunction. Splashed Do not wash with water Rain Do not submerge or use under water · To avoid damaging this meter, never drop it or subject it to shock. · Avoid storing it in places with high temperatures or humidity. · Avoid excessive temperature changes which could cause internal condensation, resulting in malfunction. · If the temperature of the meter drops to -10 deg. [. . . ]