User manual CROWN VFX2A

[. . . ] My great-grandfather invented the floor sweeper in 1876. Today, CROWN is a global leader in the design, manufacture, and service of high quality homecare products like your Spot Lifter. Thanks again, from all of us at CROWN. Mark J. Bissell President and Chief Executive Officer IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic safety precautions should be observed, including the following: Do not pick up toxic material (chlorine bleach, ammonia, drain cleaner, gasoline, etc. ) I Do not allow to be used as a toy. [. . . ] Following the Guide will greatly enhance your ability to get the best performance from your Spot Lifter for many years. Product Features Solution Tank Holds CROWN Little Green® Formula and water (See "How to use Your Spot Lifter / Filling Your Solution Tank, " Page 6) Collection Tank Empty after each use, or when dirty water reaches the indicated maximum fill line (12 oz. ). (See "When You're Done, " page 8. ) Tank Release Button Press to remove the Collection Tank. Indicator Light Glows red when unit is charging. Power Switch Activates vacuum and pump. Power Port Connect small plug of charger cord here to charge Spot Lifter. Spray Trigger Depress to spray cleaning solution and water. Standard Brush For scrubbing stubborn spots and soil. Removable for use on or off the unit. Cord with Charger Plug Plugs into electrical outlet. Spot Lifter has not been designed to operate while plugged in with the charger. Charging The Battery When charging for the first time, allow to charge uninterrupted for at least 24 hours. Your Spot Lifter should be in charge mode whenever you are not using it. When charging, the Spot Lifter and charger may become warm to the touch. This is normal, and no cause for concern. Make certain the Spot Lifter is turned OFF. Switch must be in "OFF" position to charge. When completely charged, your Spot Lifter will operate for up to 5 minutes. When completely discharged, it will take approximately 12 hours to fully recharge. To remove brush from unit, gently pull on brush tab and lift out. Check the Collection Tank and empty the tank if it is full. If Spot Lifter stops spraying, turn off Power Switch and check cleaning solution level. Never run dry. Deep Cleaning Upholstery 1. 3. Check manufacturer's tag before cleaning. "W" or "WS" on the tag means you can use your Spot Lifter. If tag is coded with an "S" (with diagonal strike-through), or says "Dry Clean Only, " do not proceed. If manufacturer's tag is missing or not coded, check with your furniture dealer. Colored stuffing may bleed through fabric when wet. Cleaning Spills From Hard Surfaces 1. 6. Activate vacuum/pump by pressing Power Switch "ON". Press front of Spot Lifter firmly against surface to vacuum spill. Press trigger to spray cleaning solution. Press front of Spot Lifter firmly against surface to vacuum cleaning solution. Check the Collection Tank and empty the tank if it is full. [. . . ] If necessary, clean with soft bristle brush. Recharge Spot Lifter. 5. FULL 9. 2. Clean exterior surfaces of Spot Lifter with a soft cloth dampened with water only. Do not use a strong detergent or other cleaners, as this may damage the finish. [. . . ]