User manual CUISINART DGB-550BK

[. . . ] Allow to cool before putting on or taking off parts and before cleaning the appliance. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been dropped or damaged in any manner. Return appliance to the nearest Cuisinart Repair Center for examination, repair, or electrical or mechanical adjustment. The use of accessory attachments not recommended by Cuisinart may cause injuries. [. . . ] When the number displayed approaches the desired setting, release the button and press repeatedly to advance one digit at a time. Be careful to make sure that the PM indicator is on if a PM time is desired. Exiting "Time Set" Mode: Exiting "Set Program Time" Mode: "Set Program Time" may be exited in any of three ways: 1. Press the "Program Set" button. This will cause the coffeemaker to revert to its previous state. If it was OFF, it will return to the OFF position. If "Programmed", it will revert to this state, and so on. Press any other button (except "Hours" or "Minutes"). "Set Program Time" will be exited and the function of that button will be executed. If neither the "Hours" nor "Minutes" button is pressed for a period of five seconds, the "Set Program Time" mode will be exited and the programmed setting will be in effect. The "Time Set" mode can be exited in one of two ways: 1. Press any button besides the "Hours" or "Minutes" button. This will exit the "Time Set" and activate the selected function. The display appears as a series of elliptical or oval-shaped dots across the lower portion of the digital readout, and indicates the selected temperature relative to the holding temperature preset at the factory. pm Exiting "Set Temperature" Mode: There are three ways to exit "Set Temperature" mode: 1. Press any button besides (-), (+) or "Temp Set". The function of the button pressed will be executed. If neither the (-) nor (+) button is pressed for a period of five seconds, the "Set Temperature" mode will be exited. NOTE: If, at any time during the life of the coffeemaker, the temperature display bar begins to flash and the Temp Set button has no effect on the display, this indicates damage to the Coffee Temperature Monitor. Otherwise the coffeemaker will continue to function normally. Because there are no user serviceable parts inside, the coffeemaker must be returned to an authorized Cuisinart Repair Center if servicing is desired. If you use a lot of milk in your coffee, set temperature higher than normal. If you prefer cooler coffee, lower the temperature. We encourage you to experiment and determine what is best for you. Please note that the heater plate on the coffeemaker is not powerful enough to raise the temperature of the coffee in the pot, once coffee has been brewed. This feature is designed as a "preset" and will affect the coffee during the brewing cycle. [. . . ] Turn the coffeemaker ON to see if the self-clean light continues to flash. If it does, turn it OFF and then repeat the cleaning procedure with a fresh solution of vinegar and water. If the self-clean light no longer flashes, turn the coffeemaker to OFF and then run one cycle of fresh cold water through the unit before using the unit again to brew coffee. Note on the SelfClean Function: Pressing the "Self-Clean" button cancels all other settings. If it is pressed accidentally, press it again to return the coffeemaker to all its previous settings. [. . . ]