User manual CUISINART DGB-600BC

[. . . ] Grind & Brew ThermalTM 10-Cup Automatic Coffeemaker DGB-600 For your safety and continued enjoyment of this product, always read the instruction book carefully before using. IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock and/or injury to persons, including the following: 1. To protect against electric shock, do not place cord, plug, or base unit in water or other liquids. Close supervision is necessary when any appliance is used by or near children. Always unplug from outlet when not in use and before cleaning. [. . . ] If neither the "Hours" nor "Minutes" button is pressed for a period of five seconds, the "Set Program Time" mode will be exited and the programmed setting will be in effect. The "Time Set" mode can be exited in one of two ways: 1. Press any button besides the "Hours" or "Minutes" button. This will exit the "Time Set" and activate the selected function. If neither the "Hours" nor "Minutes" button is pressed for a period of five seconds, the "Time Set" mode will be exited. Insert the Water Filter a. Remove the filter from polybag and soak in cold tap water for 15 minutes. b. Remove the water filter holder from the coffeemaker by lifting it out of the reservoir area with your thumb and forefinger. Using thumb of other hand, gently press down and pull toward you. d. Place the filter in the holder and close the water filter holder; you will hear a snap indicating filter is in place. NOTE: Caution must be used when inserting the charcoal filter. Improper placement in the holder can cause tearing of the filter skin. e. Hold the filter under cold running tap water for 10 seconds to flush. You should place the hole openings in the side of the unit directly under the water stream. Allow the filter to drain completely. 2. Setting the Program Time: When you press the "Program Set" button, it displays the current program time (default time 12:00 p. m. ). Entering "Set Program Time" Mode: Press and hold the "Program Set" button (about 2 seconds) until the green light and LCD display begin to flash. This signals that you have entered the "Set Program Time" mode. The desired time can be set by pressing the "Hours" and "Minutes" buttons to scroll forward through the digits. Pressing and holding either button will allow you 8 1. Fill the Water Reservoir Open the reservoir lid by pushing the release button and lifting up. Pour the desired amount of water in the reservoir using the step water indicator located at the rear of the reservoir. Add Beans Lift the grinder basket lid, using the recess on either side. Fill the basket with the desired quantity of beans. (Use 1 level scoop of whole beans per cup. [. . . ] One cycle should be sufficient to adequately clean the coffeemaker. When the cycle is completed and the five beeps sound, turn coffeemaker off. Repeat operation, this time using fresh cold water. purposes of this warranty will be the date of manufacture. If your coffeemaker should prove to be defective within the warranty period, we will repair it (or, if we think it necessary, replace it) without charge to you. [. . . ]