User manual CURTIS CR4975

[. . . ] STEREO RADIO, CD-R/RW PLAYER WITH ALARM CLOCK OWNER'S MANUAL MODEL NO. CR4975 PLEASE READ BEFORE OPERATING THIS EQUIPEMNT SAFETY INSTRUCTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. LASER SAFETY: This unit employs a laser. Only qualified service personnel should attempt to service this device due to possible eye injury. [. . . ] Unauthorized substitutions may result in fire, electric shock or other hazards. SAFETY CHECK Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. WALL OR CEILING MOUNTING The product should be mounted to a wall or ceiling only as recommended by the manufacturer. DAMAGE REQUIRING SERVICE Unplug the product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a. When the power-supply cord or plug is damaged. If liquid has been spilled or objects have fallen into the product. If the product has been exposed to rain or water. If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, as an adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation. If the product has been dropped or the cabinet has been damaged. When the product exhibits a distinct change in performance­this indicates a need for service. HEAT The product should be situated away from heat sources such as radiators, heat registers, stoves or other products (including amplifiers) that produce heat. NOTE TO CATV SYSTEM INSTALLER This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. 3 INSTALLATION Unravel the AC cord and connect it to a conveniently located AC outlet having 120V and 60Hz only. The Clock Display will illuminate and "12:00" will appear in the window. AC Outlet NOTE: If the AC plug does not fit into a nonpolarized outlet, do not file or cut the wide blade. it is the user's responsibility to have an electrician replace the obsolete AC Plug outlet. If the AC cord is disconnected or if there is a power failure, this electronic clock is designed to continue operating internally (without showing the time on the Clock Display) with a 9 volt battery (not included). To install the battery, press and lift open the compartment cover. Connect the battery to the terminals of the battery snap inside the compartment (use of an alkaline battery is recommended) and snap the battery comaprtment cover back into place. Be sure to check the condition of the battery periodically by disconnecting the AC cord and connecting it again two or three minutes later. The preset times should continue operating. If the present time does not appear, it indicates the battery is dead or not connected properly. [. . . ] DIMMER BUTTON To cancel Sleep SNOOZE button. time, press the 1 Press the DIMMER button to the HI (in) position to make the display brighter or to the LOW (out) position to make the display dimmer. 12 CARE AND MAINTENANCE Caring for Compact Discs · Treat the disc carefully. Never allow your fingers to come in contact with the shiny, unprinted side of the disc. · Do not attach adhesive tape, stickers, etc. · Clean the disc periodically with a soft, lint-free, dry cloth. [. . . ]