User manual CURTIS RCD641

[. . . ] Table of Contents Page No PRECAUTIONS ----------------------------------------------------------------------------------------IMPORTANT SAFETY INSTRUCTION ------------------------------------------------------------ E-2 E-3 E-6 E-7 E-8 E-9 E-10 E-10 E-11 E-11 E-12 E-12 E-13 STEREO HI-FI SYSTEM With CD PLAYER And AM/FM PLL SYNTHESIZED TUNER WARNING ----------------------------------------------------------------------------------------------INSTALLATION ----------------------------------------------------------------------------------------OPERATING ELEMENTS --------------------------------------------------------------------------SETTING UP AND CONNECTING THE STEREO SYSTEM -------------------------------CLOCK AND TIMER BASIC OPERATION -------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- LISTENING TO THE RADIO PLAYING CD'S ----------------------------------------------------------------------------------------CARE AND MAINTENANCE ---------------------------------------------------------------------- TROUBLE SHOOTING GUIDE --------------------------------------------------------------------SPECIFICATIONS ------------------------------------------------------------------------------------- RCD641 OWNER'S MANUAL -1- PRECAUTIONS Please take good note of the following instruction: l The unit must be connected to the power voltage, which is the same as the local area. If not, there is a danger of "burning" the unit that causes a fire. Do not expose to the temperature higher than 35ºC. Avoid installation near heaters or in areas subjected to direct sunlight. [. . . ] Take to an approved service center if repairs are necessary. Do not operate unit if it is not working normally or has been damaged in any way. Turn unit off, unplug it from the power source and consult service personnel. This will increase the chance of electrical shock. Do not leave unit unattended when in use. Do not listen to headphones at high volumes. Do not attempt to create your own stand for the unit. Do not push object into any holes, slots or openings on unit. 3. 4. 5. -6- -7- OPERATING ELEMENTS Front view 1 1. / SEARCH / TUNING - Button Left side view 15. RESET Switch - Reset the unit with a sharp tip 16. FM Antenna Terminal FM 75 ohm Antenna Socket (optional) 20. BAND Button 23 15 7 8 9 10 11 12 13 14 16 SETTING UP AND CONNECTING THE STEREO SYSTEM Antenna connection FM: Install the FM Antenna wire connecting plate to FM Antenna Terminal (19) and tighten it with a screwdriver. If stereo broadcast received, the STEREO indicator will be displayed on the display (1) This unit is equipped with a built-in directional ferrite antenna, move and rotate the unit for best reception. AM: 17 18 23 19 20 21 22 24 Speaker connection To insert the speaker cables by pushing down the terminal lever of Left Speaker Terminal (21) and Right Speaker Terminal (22). Please ensure the cables are connected into the speaker terminals with the correct polarities. Connect the left speaker to the terminals L and the right speaker to the terminals R. LINE IN (AUX IN) connection Grey 25 26 27 28 29 30 31 32 33 34 45 48 35 36 37 38 39 40 41 42 43 44 1. Connect one end of a RCA plug signal wire (not included) to Aux Input Socket (18) and the other end of wire to your home equipment. Make sure the polarity of the right and the left channel is correct. Press the POWER (4) (43) to switch on the unit 3. Press LINE IN (29) on the remote control while display indicates "LINE". Connect one end of a RCA plug signal wire (not included) to Subwoofer Socket (17) and the other end of wire to your subwoofer. [. . . ] AM or FM, no sound. AM: The bar antenna is not positioned correctly. You have tuned to a mono station or station too weak. Unit not at Tuner function AM or FM band. Volume at minimum. Reposition the unit until best reception is obtained. [. . . ]