User manual CURTIS SCR2608

[. . . ] Under Cabinet CD Clock Radio with Remote MODEL SCR2608 INSERUCTION MANUAL Operating Instructions BEFORE OPERATION THIS PRODUCT, READ, UNDERSTAND, AND FOLLOW THESE INSTRUCTIONS. Be sure to save this booklet for future reference. IMPORTANT SAFETY INSTRUCTIONS The Lightning flash with arrowhead symbol, with an equilateral triangle is intended to alert the user of the presence of uninsulated dangerous voltage within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The exclamation point within an equilateral triangle is intended to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. THESE IMPORTANT SAFETY INSTRUCTIONS ARE INCLUDED, AS APPLICABLE TO THE APPLIANCE, CONVEYING TO THE USER THE FOLLOWING INFORMATION: Heed Warnings- All warnings on the appliance and in the operating instructions should be adhered to. Follow instructions- All operating and use instructions should be followed. [. . . ] The washers must be used on metal cabinets, and on wood cabinets if you did not countersink the drilled holes. Position washers, flat side down, and place screws into the holes. If your cabinet does not have an overhang, go to Step 7. Hold screw heads down while you push the selected spacers onto the screws under the cabinet. Be sure to push up spacers until they fully nested (if more then one is in used) Step 7 Align radio under the screws. Hold the screw holes in the top of the clock radio against the mounting screws and partially tighten the screws. Do not fully tighten until all 3 screws have been started. 10:27pm -> 9:27am) 4. Press MEMORY/C-ADJ button, enter to minute adjustment mode. ( Minute will begin to flash) d . Press SKIP >>| or SKIP |<< button to desired time. 9:27am -> 9:20am) e) and then press MEMORY/C-ADJ button, finish clock adjustment. NOTE: For 12 Hour display, If the time is pm, then PM icon will appear. And " AM" will not indicate on the display Time setting is invalid if the time always flashes. ALARM TIME SETTING 1. While in the CD or Radio mode, Press "Display/AL. Set" one time to enter the alarm time set mode. (The bell icon " will appear and begin to flash) " 2. Press and hold MEMORY/C- ADJ button for 2 seconds, enter to alarm hour adjustment mode (Alarm hour will begin to flash) 3. Press SKIP >>| or SKIP |<< button to desired time. 10:27pm -> 9:27am) Press MEMORY/C-ADJ button, enter to alarm minute adjustment mode. ( Alarm minute will begin to flash) Press SKIP >>| or SKIP |<< button to desired time. 9:27am -> 9:20am) and then press MEMORY/C-ADJ button, finish clock adjustment. After setting the alarm time. Press AL. SET KEY (on the remote controller) repeatedly to select Buzzer mode. ("BUZZ" indicator will appear) b. The alarm buzzer will sound for 3 minutes at the set alarm time. Press Power/AL. Off button to turn off the alarm when it sounds. TO WAKE UP TO CD: a. [. . . ] Press SKIP >>| button once to skip to the beginning of the next track. SEARCHING TRACKS Press and hold during play Backward------------SKIP |<< button Fast Forward------------SKIP >>| button PROGRAMMED PLAYBACK Up to 20 tracks can be programmed in to play in any desired sequence. Turn on the unit by pressing the POWER/ AL. Press the CD button to select CD function. [. . . ]