User manual CURTIS STC580

[. . . ] OWNER'S MANUAL 58 GHz 58 GHz In Use Low Batt. Cordless Phone PA GE RED IAL PAU SE VO L CH MUT E FLA SH MEM O TAL K ABC DEF 1 GHI 2 JKL 3 MNO 4 PRS 5 TUV 6 WXY 7 8 OPER 9 * 0 # chg / in use 5. 8 GHz Cordless Telephone PLEASE READ BEFORE OPERATING THIS EQUIPMENT Model : STC580 Contents Safety Instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Handset Controls. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Base unit Controls. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] This adaptor is available at the same place you purchased your telephone. ) 6. We recommend not placing this unit next to appliances. 120V WALL TELEPHONE POWER-IN OUTLET JACK CONNECTION JACK TELEPHONE LINE CONNECTION JACK TONE/PULSE SELECT SWITCH AC ADAPTOR TELEPHONE LINE CORD 7 Getting Started 7. Install the HANDSET BATTERY PACK by plugging it into the BATTERY CONNECTOR inside the BATTERY COMPARMENT. Place the BATTERY PACK inside the BATTERY COMPARTMENT. Slide the HANDSET BATTERY COMPARTMENT COVER firmly into place in its closed position. IMPORTANT: Before initial use, charge the HANDSET for 12 hours. When you have finished your call, either press the TALK button or place the HANDSET on the BASE UNIT. The HANDSET IN USE LED indicator will turn off and the BASE UNIT IN USE/CHARGE LED will light up to indicate that the HANDSET is charging. VOL NOTES: 1. During a telephone conversation, press the VOL (VOLUME) button to select the desired HANDSET receiver volume level from MAXIMUM, HIGH, MEDIUM, or LOW. Press the (+) button to increase, or press the (-) button to decrease the volume level. A double "beep" sound will be heard when the (+) or (-) button is pressed further after the MAXIMUM or the LOW volume level. The BASE UNIT does not have a ringer and does not ring when receiving an incoming call. If you are too far away from the BASE UNIT, the HANDSET emits "beep" sounds to warn you that the background noise level is too high for proper communication between the HANDSET and the BASE UNIT. When you hear this sound, you should move closer to the BASE UNIT to reduce the noise level. Otherwise, the call will automatically cut off. 9 Cordless Telephone Operation Receiving Calls with the HANDSET on the BASE UNIT 1. When the phone rings, lift the HANDS E T. NOTE: The HANDSET RINGER ON/OFF switch must be in the "ON" position for ringer to operate. Start your conversation. REDIAL PAUSE In Use Low Batt. 3. To end your conversation, either press the TALK button or place the HANDSET on the BASE UNIT. If you place the HANDSET on the BASE UNIT CHARGE CRADLE, you activate the automatic STANDBY feature. CH VOL MUTE MEMO FLASH TALK 3 Receiving Calls with the HANDSET off the BASE UNIT 1. When the phone rings, press the TALK button. [. . . ] However, when advanced written notice is not possible, the telephone company may temporarily discontinue service without notice if such action is necessary under the circumstances. The telephone company may make changes in its communication facilities, equipment, operations, or procedures that could affect the proper operation of your equipment. If they do, you will be provided with advance notice as to give you an opportunity to maintain uninterrupted service. This equipment may not be used on coin service provided by the telephone company. [. . . ]