User manual CURTIS STID991

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual CURTIS STID991. We hope that this CURTIS STID991 user guide will be useful to you.

Lastmanuals help download the user guide CURTIS STID991.


Mode d'emploi CURTIS STID991
Download
Manual abstract: user guide CURTIS STID991

Detailed instructions for use are in the User's Guide.

[. . . ] Use only with a cart, stand, tripod, bracket, or table recommended by the manufacturer or sold withe the product. any mounting of the product should follow PORTABLE CART WARNING the manufacturer's instructions, and should use a (symbol provided by RETAC) mounting accessory recommended by the manufacturer. 8A. An appliance and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the appliance and cart combination to overturn. [. . . ] Serial Number ANTENNA LEAD IN WIRE GROUND CLAMP ANTENNA DISCHARGE UNIT (NEC SECTION 810-20) CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. DANGEROUS VOLTAGE Uninsulated Dangerous Voltage, that may be of sufficient magnitude to constitute a risk of electric shock to persons is resent within this product's enclosure. ATTENTION The Owner's Manual contains important operating and maintenance instructions. For your safety, it is necessary to refer to the manual. This equipment has been tested and found to comply with the limits for a Class B digital device. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/ TV technician for help. ELECTRIC SERVICE EQUIPMENT GROUNDING CONDUCTORS (NEC SECTION 810-21) GROUND CLAMPS POWER SERVICE GROUND ELECTRODE SYSTEM (NEC ART 250, PART H) NEC-NATIONAL ELECTRICAL CODE S2898A EXAMPLE OF ANTENNA GROUNDING AS PER ANTIONAL ELECTRICAL CODE 18. Be sure to keep the Operating Instructions for future reference. All warnings and cautions in the Operating Instructions and on the unit should be strictly followed, as well as the safety suggestions below. - the heating system has just been turned on - the unit is used in a very humid room - the unit is cooled by an air conditioner When this unit has condensation inside, it may not function normally. Should this occur, leave the unit for a few hours, then try to operate again. 17 4 18 19 20 Installation 1 Water and moisture - Do not use this unit near water, such as near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, swimming pool, or the like. 2 Heat - Do not use this unit near sources of heat, including heating vents, stoves, or other appliances that generate heat. 3 Mounting surface - Place the unit on a flat, even surface. 4 Ventilation - The unit should be situated with adequate space around it so that proper heat ventilation is assured. Allow 10 cm(4 in. ) clearance from the rear and the top of the unit and 5 cm (2 in. ) from each side. - Do not place the unit on a bed, rug, or similar surface that may block the ventilation openings. - Do not install the unit in a bookcase, cabinet, or airtight rack where ventilation may be impeded. 5 Objects and liquid entry - Take care that objects or liquids do not get inside the unit through the ventilation openings. [. . . ] Tuner section Frequency range: FM : 88-108 MHz AM : 530-1700 KHz General Speaker: 77 mm cone type (2) Output: Headphones jack (stereo jack) Power output: 1. 0 W +1. 0 W Power requirements: DC 12 V using eight size C batteries, AC 120V, 60Hz Weight: 2. 4Kg (excluding batteries) Dimensions: 290(W)x160(H)x250(D) mm Accessory: AC cord (1) Deck section Track format: Frequency range: Recording system: Erasing system: Heads: 4 track, 2 channels Normal tape DC bias Magnet erase Recording / playback head Erasure head F TUNER OPERATION 1 Set function to RADIO. For better reception - Extend the FM antenna and orient it for the best reception; AM antenna is inside the unit. Position the unit for the best reception. CD player section Disc: Scanning method: FM ST: Reception is stereo. When receives FM stereo signal, the FM ST indicator lights up. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE CURTIS STID991

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual CURTIS STID991 will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag