User manual CURTIS TID5030

[. . . ] Plug the remaining end of the telephone line cord into an existing telephone wall jack. Run the AC power cord through the provided cable channel for flush desk mounting. Plug the AC power cord into the AC(120V/60Hz) wall jack. Plug the handset coiled cord into the bottom of the handset. [. . . ] The new call indicator will being to flashing. SPEED DIAL OPERATION Storing speed dial 1. While continuously holding down the hook switch or when the telephone line cord is disconnected 2. Dial the number you wish to dial (the display can be show up to 12 digits) using the digital keys or review the incoming or outgoing number. And then press digital<0-9 key> to store the number in the location which you desire to store in. Note: there is a time-out for storing numbers, if the times out before the number is stored, try again please. Press the [AUTO] key, and then press the digital key (1-0) where the number was stored. Note: there is a time-out for storing numbers. If the unit times out before the number is stored, try again. CALLER ID When you are subscribed to caller ID service and a call is received, the unit will display the caller information sent by the telephone company . including: telephone number (if available), and the date and the time of the call. Calls are put in sequence and numbered to indicate their place in the sequence. When more than 80 calls have been received, the oldest messages are replaced with the new call information. When you receive more than one call from the same telephone number, the display will show REP in the upper right corner to indicate it is a repeat call. Only the most recent repeat call is recorded, and REP indication goes away after the record has been viewed. TO DELETE CALL(S) FROM MEMORY For Incoming Call(s): 1. Press [ ], [ ] to select the phone number(s). Press the (DELETE) button twice within 2 seconds to delete. Press (OUT) & the (DELETE) buttons twice within 2 seconds to delete. ALL the phone number(s) stored in the memory will be delete(d). Note: In on-hook mode, Press<DELETE> to delete the pre-dialed numbers one-by-one. In off-hook mode, Press<DELETE> to start calling timer. IMPORTANT: All messages will be deleted when battery is removed. . RADIO OPERATION INSTRUCTION AM/FM band selector . . . Slide this selector to either AM or FM to select the desired radio band. Turn this knob to the desired radio station. To regulate the loudness of the radio, rotate the CONTROL clockwise to desired position. If you wish to be aw3akened preset time by the "Buzzer" rotate the CONTROL counter-clockwise until a "click sound is heard. [. . . ] Line out of order, check phone in another room's jack or in your neighbor's home 4. Phone does not ring 5. Incoming outgoing and voice 1. Are you using too many phones on one line?(the total REN of all phones on the same line should not be greater than the maximum REN for your calling area. ) 2. Telephone company may be using unusual ringing methods. Are other phones off the hook at the same time? [. . . ]