User manual CURTIS TID582

[. . . ] We recommend the unit be mounted at the front edge of the cabinet. Important: For secure mounting, the screws must go into the radio to a depth of at least 3/8". [. . . ] If the overall length from the bottom of the cabinet shelf to the bottom of the over hand is more the 1 3/4". A shim can be made from a sheet of plywood, using the template to locate the central lines for drilling the 3/16" mounting holes; the shim can be located between the cabinet shelf bottom and spacers. Make sure the wood is at least as thick as the excess over 1 3/4". If a shim is necessary, longer screws are required. Longer screws (Type#10-32) are available at most local hardware stores Cut out the template on the line indicated. The template size and the screw hold positions are identical to the top of the Clock radio. Mounting Procedure Step 1. If your cabinet does not have a overhang : a) Position template in desired location on underside of cabinet, flush with front edge. Step 4 If your cabinet does not have an overhang. Select the spacer or combination of spacers that is equal to or longer than the cabinet overhang. Installation with supplied washers (no Countersink) Step 5. The washers must be used on metal cabinets, and on wood cabinets if you did not countersink the drilled holes. Position washers, flat side down, and place screws into the holes. If your cabinet does not have an overhang, go to Step 7. Hold screw heads down while you push the selected spacers onto the screws under the cabinet. Be sure to push up spacers until they are fully nested (if more then one is in used) Step 7 Align radio under the screws. [. . . ] Be sure to push up spacers until they are fully nested (if more then one is in used) Step 7 Align radio under the screws. Hold the screw holes in the top of the clock radio against the mounting screws and partially tighten the screws. [. . . ]