User manual CURTIS TID855

[. . . ] Water and moisture- The appliance should not be used near water. For example, near a bathtub, washbowl, kitchen sink, or near a swimming pool, and the like Ventilation- The appliance should be situated so that its location or position does not interfere with its proper ventilation. For example, the appliance should not be situated on a bed, sofa, rug, or similar surface that may block the ventilation openings; or, placed in a built-in installation, such as a bookcase that impedes the flow of air through the ventilation openings. Heat ­ The appliance should be situated away from heat sources such as radiators, heat registers, stoves, or other appliances (including amplifiers) that product heat. [. . . ] The template size and the screw hold positions are identical to the top of the Clock radio. Mounting Procedure Step 1. If your cabinet does not have a overhang: a) Position template in desired location on underside of cabinet, flush with front edge. b) Then tape template in pace and go to step 2. If your cabinet have overhang: a) Measure the thickness of the overhang. b) Fold front of the template downward along the printed guideline that is closet to the thickness of your cabinet. c) Tape fold-down portion to backside of overhand, tape template to cabinet underside. Note: If your cabinet has glue blocks or other obstructions, cut out corresponding areas on the template to clear them. Do not cut or cut through the screw holes indicated on the template. CAUTION: It is recommended that safety glasses be worn while drilling screw holes to prevent the possibility of eye injury. Step 2 Drill 1/4" inches diameter holes through the underside of the cabinet bottom shelf using the three points marked on the template. Helpful Hints: On wooden cabinets you may want to mark and start the drill holes with a nail or an awl. Be sure to hold the drill very firmly against the cabinet to reduce "walking" of the drill bit from the markings. Using masking tape above the hole locations on inside of wooden cabinet shelf to help reduce splintering. If installing the unit under a wood cabinet, you may wish to countersink the drilled hold for the INSIDE of the cabinet if a countersink the holes use the supplied washers. In the event of a power outage, the time will not appear on the clock LCD Display, however the clock will continue to operate and the actual time will be maintained. The Clock LCD Display and other functions will resume once electrical power is restored if used the backup battery; Remove the battery if the clock is not used or stored for long periods of time CLOCK SETTING 1. 2. While in the CD or Radio mode, Press "Display/AL. Set" two time to enter the time mode. To deactivate the alarm (CD playing); Press either the STOP Button or Press the Power/AL. Power on the unit by pressing the Power/ AL. off button. Press the STOP/Band button to Select AM or FM . Tuning your favorite radio station and your desired listening level. Press AL. SET KEY (on the remote controller) repeatedly to select tuner mode. ("tuner" indicator will appear ) g. The radio will sound at the set alarm time. Snooze Function If you want to snooze a few more minutes press the SNOOZE BUTTON (on the remote control) will deactivate the sound for 9 minutes. [. . . ] Press once more PLAY/PAUSE button to momentarily pause Pausing (" cd: 1" indicator will begin to flash) Notes: While in the Pause mode. SKIP |<< scan or SKIP >>| scan can in use to rewind or go to next song. 8. To stop the playback, Press STOP/BAND button . SKIPPING TRACKS Press during play. Backward------------SKIP |<< button Fast Forward------------SKIP >>| button Press SKIP |<< button twice to skip to the beginning of the previous track. [. . . ]